I. PREPARATION OF VEHICLE INTERIOR
1. Carefully trim headliner as shown.
Caution: Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. Make sure that the 8 1/2" cut is centered left to
right in vehicle. See Figure 1.
2. Remove and retain (2) two O.E. screws which secures O.E. bracket to roof brace. See Fig. 1.
FIGURE 1
3.Install console mounting bracket (item 2 pg 2) over O.E. bracket on roof brace. Secure rear of bracket using (2) two O.E. screws. Secure front of bracket using (2) two #8 x 3/4" screws (item 1 pg 2) See Figure 2.
FIGURE 2
INSTALLATION INSTRUCTION #
3
II.PREPARATION OF CONSOLE FOR INSTALLATION
4.Install the video system in console (item 3 pg 2) and secure using hardware supplied with video system. Start all screws before tightening. Begin with the rear center screw, then alternately tighten screws around the perimeter of pod. See Figure 3. Refer to owner’s manual supplied with video system. Caution: Do not overtighten screws.
July 7, 1999
Printed in the U.S.A.