Toshiba DK Backup, DK Admin manual Installing DKBackup, Check System Requirements

Installing DKBackup 3

Step 1: Check System Requirements

For optimum performance, run DKBackup on a personal computer with the following minimum specifications:

♦IBM-compatible 386/486 personal computer or higher level

♦20MB or larger hard drive

♦CD-ROM or 3.5" 1.44KB high-density floppy drive

Note DKBackup software is distributed on a CD-ROM disk. Installation can be performed using the CD-ROM disk or from floppy disk(s) copied from the CD-ROM DKBackup install program.

♦VGA or SVGA monitor preferred

♦640KB RAM (minimum)

♦Microsoft® MS-DOS®6.22, Windows® 3.11 or higher (Windows 95, 98 or Windows NT® 4.0 recommended).

♦A laser printer is recommended

♦For network users, a minimum of 2MB of disk space is required for each person using DKBackup on the network.

♦DKBackup hardware key (green or red)

DKBackup is a MS-DOS program that can be installed and run under Microsoft

Windows 3.11, 95, 98, NT or MS-DOS (6.22 or higher). The installation and run instructions in this chapter include both Windows and DOS installation information.

Important!

●

●

If your PC has Windows installed, setting your Windows SYSTEM.INI and DOS CONFIG.SYS files with the commands below may help DKBackup run on your PC.

SYSTEM.INI

[NonWindowsApp]

COMMANDENVSIZE=1024

DOS CONFIG.SYS

SHELL=C:\COMMAND.COM /e:1024 /p

If DKBackup displays a “Run time error” message during installation or operation, erase all “ntx” files under the customer directory (XXX.DK) and the “data” directory.

Installing DKBackup 17