DK424 Release 4.0 Upgrade Programming Example –––––––––––––––––––––––––––––––––––––––––––––––––––

Programs *04, 05, 09

There is no change to the data in these programs when upgrading to Release 4.0. Note that DID/Tie ports do not cause Phantom DN ports to shift in Strata DK Release 1~Release 3 systems, so they do not shift in Program *04 when upgrading to Release 4.0. Also, the data in Program 09 is DN numbers and not port numbers, so data in Program 09 does not change when upgrading to Release 4.0.

Program *09

Data in this program must be changed to adjust for port shifting caused by the RDDU DID line PCB in slot 13 (see Figures 33 and 34):

Before the Upgrade

After the Upgrade

Port 000-007; Data 100-107

Port 000-007; Data 100-107

 

 

Port 008-015; Data 108-115

Port 008-015; Data 112-119

 

 

Port 016-019; Data 116-119

Port 016-019; Data Blank

 

 

Programs 10-1 through 10-4

There is no change to the data in these system programs when upgrading to Release 4.0. Port numbers are not assigned to system programs so no adjustments are necessary.

Program 13

If the Message Center is the Front Office Telephone (PDN 112), data in this program must be changed to adjust for port shifting caused by the RDDU DID line PCB in slot 13 (see Figures

33and 34):

Data for Program 13 before the upgrade = 012

Data for Program 13 after the upgrade = 008

If the Message Center is the Lobby Telephone (PDN 100), data in this program must not be changed to adjust for port shifting caused by the RDDU DID line PCB in slot 13. This is because Port 000 did not shift after the upgrade (see Figures 33 and 34):

Data for Program 13 before the upgrade = 000

Data for Program 13 after the upgrade = 000

Programs 15, 16, and 17

There is no change to the data in these programs when upgrading to Release 4.0. These are CO line programs and port numbers are not assigned in them so no adjustments are necessary.

Program *17

If the DID Intercept Destination is the Back Room Telephone (PDN 119), data in this program must be changed to adjust for port shifting caused by the RDDU DID line PCB in slot 13 (see Figures 33 and 34):

Program *17 data for DID lines 001~004 before the upgrade = 019

Program *17 data for DID lines 001~004 after the upgrade = 015

158

DKAdmin/DKBackup

Page 168
Image 168
Toshiba DK Admin, DK Backup manual 158, Programs *04, 05