Step 4: Install DKBackup ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Step 4: Install DKBackup

DKBackup is a DOS application program that can be installed and run in either DOS or as a Windows DOS session.

CAUTION! If any earlier DKBackup (280Backup) release is already installed on the PC, do not delete it; install DKBackup Release 4.XX over the existing DKBackup (280Backup) version as described below. DKBackup is always installed in the 280Backup directory, overwriting the old DKBackup (280Backup) operating software but not customer database directories. Existing 280Backup customer data can be used with DKBackup Release 4.XX.

Note DKBackup software is also available from the Toshiba FYI Internet site.

Windows PC from CD-ROM

Notes

When installing DKBackup to run as a DOS session in Windows NT, the install program assumes that the default directory name (WINNT) and the default system drive (Drive C) contain the system files. The installation procedure looks for this directory (C:\WINNT) and, if found, copies the necessary drivers for Windows NT onto the hard disk.

Be sure to exit all programs running in Windows before starting.

1.Insert the CD-ROM into your CD-ROM drive. The Main Menu appears.

...or if the Main Menu does not appear after you insert the CD-ROM, click Start, Run, then Browse. Select your CD-ROM drive from the Look in: pull down list. Locate and double- click mainmenu.exe. The Main Menu opens.

2.From the Main Menu, select “Install DKBackup” and follow the prompts.

Important! Remember that the “Install DKBackup” selection in the Main Menu is a Windows application, but the actual DKBackup application is a DOS/Windows DOS session application.

Windows PC from Floppy Disks

Note Be sure to exit all programs before running the Setup program.

1.Insert Floppy Disk #1 into the floppy drive and click Start, then Run. Type a:\setup (or b:\setup). Click OK. Follow the prompts to install DKBackup.

CAUTION! During installation, selecting “New Installation” overwrites the existing DKBackup customer list if you already have DKBackup or 280Backup installed on your PC. Although the customer list is overwritten, you can still retrieve the existing customer data associated to that name by adding that customer’s name using the “Maintain Customer” selection on the newly installed DKBackup. Do this for each customer name that is overwritten on the list.

2. Reboot your PC when prompted at the end of installation.

20

DKAdmin/DKBackup

Page 30
Image 30
Toshiba DK Admin, DK Backup manual Install DKBackup, Windows PC from CD-ROM