Toshiba DK Admin, DK Backup manual DN Does Not Exist. Please Refer to Program *04

Flexible Button Programming Section –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

3.Press F2 to make the key a Primary DN, F3 a Secondary DN, F4 a Phantom DN, or F6 to change the key feature.

If you press F3 or F4, a pop-up list appears and you must enter a primary or secondary number. If the number you enter does not exist, the following warning message appears and you must re-enter the number.

DN Does Not Exist. Please Refer to Program *04.

...or

press F5 to deactivate or blank out a key assignment

...or

if you press F6, a feature pop-up list displays (shown right).

Highlight the feature you want to assign to the button and press Enter. Some entries (such as the CO Line feature) require you enter a value when making an assignment. The selected feature replaces the previous feature.

Note You can only assign a feature to one button within a port. If you attempt to assign a feature already assigned, an error message displays.

...or

press F8 to add multiple speed dial key assignments.

Important! You can only use this key when you are assigning more than one speed dial key at a time. If you have not just added a speed dial key assignment, the message Must Assign System/Station Speed Dial First displays.

If you leave the cursor in the same field and continue to press F8, the speed dial key number increments. To add consecutive speed dial key assignments, you must continue to highlight the next field before pressing F8.

➤To copy selected keys to selected ports

1.Press Ctrl+F2 and a pop-up dialog box displays (shown at right).

2.Press any key to continue.

3.Highlight a key and press the spacebar to select. A asterisk appears next to your selection. Continue until all the keys you want to copy have been selected.

62 DKAdmin/DKBackup