Toshiba DK Admin, DK Backup manual Power Up DKBackup PC, DKBackup Hardware Connections

Step 2: Power Up DKBackup PC ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

●

●

From C:\280BCKUP\Data, type del *.ntx and press Enter.

From C:\280BCKUP\XXX.DK, type del *.ntx and press Enter.

●Run “ReIndex Files” under Options/System Utilities Menu each time before you start to use DKBackup.

●Always exit DKBackup before you turn your computer off.

Step 2: Power Up DKBackup PC

Note The DKBackup or DKAdmin Hardware Key must be installed on the PC LPT1 port,

to allow the DKBackup program to be used after it is installed. If you install DKBackup without the key, it will not run.

1.Install the DKBackup hardware key (green or red) on the LPT1 parallel printer port as shown in Figure 3.

DKBackup Hardware Key

(Teal green or red color required for DKBackup)

DKBackup

IBM Compatible

Personal Computer

1049

KEY LABEL

Parallel Printer

Screws Cable

(Green)(Red)

4DGFCH - B or 4ELVCH - B

LPT1 Parallel Printer

Connector on Back

Printer

Parallel Printer Port

Figure 3 DKBackup Hardware Connections

Notes

●

●

If you wish, you can install a printer on the end of the LPT1 Admin Hardware Key.

The printer can be installed and used on the LPT1/Backup Hardware Key. But, it is not necessary to install a printer to enable DKBackup to be installed or used.

2. Turn on your computer.

18 DKAdmin/DKBackup