Toshiba DK Admin, DK Backup manual Power Up DKAdmin PC, DKAdmin Hardware Connections

Step 2: Power Up DKAdmin PC –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

●

●

From C:\280ADMIN\Data, type del *.ntx and press Enter.

From C:\280ADMIN\XXX.DK, type del *.ntx and press Enter.

●Run ReIndex Files under Options/System Utilities Menu each time before you start to use DKAdmin.

●Always exit DKAdmin before you turn your computer off.

Step 2: Power Up DKAdmin PC

Note The DKAdmin Hardware Key must be installed on the PC LPT1 port, to enable the DKAdmin program to be used after it is installed. If you install DKAdmin without the key, it will not run.

1.Install the DKAdmin hardware key (red) on the LPT1 parallel printer port as shown in Figure 2.

Red DKAdmin Hardware Key (required for DKAdmin)

DKAdmin

IBM Compatible

Personal Computer

1994

KEY LABEL

Parallel Printer

Screws Cable

4ELVCH - B

LPT1 Parallel Printer

Connector on Back

Printer

Parallel Printer Port

Figure 2 DKAdmin Hardware Connections

Notes

●

●

If you wish, you can install a printer on the end of the LPT1 Admin Hardware Key.

The printer can be installed and used on the LPT1/Admin Hardware Key. But, it is not necessary to install a printer to enable DKAdmin to be installed or used.

2. Turn on your computer.

8 DKAdmin/DKBackup