Toshiba DK Backup, DK Admin manual 105, Baud Rate Selection

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– Restore Data

7.After completing the steps on the screen, press Enter (twice) and the Baud Rate Selection screen displays (shown below). This screen enables you to set the DKAdmin/ DKBackup PC COM port baud rate which must match the baud rate of the TTY or modem port set by the programming telephone.

Baud Rate Selection

Please adjust the baud rate of DKBackup PC COM port to match the new PIOU, PIOUS, RSSU or RSIU/RSIS you may have installed.

Baud Rate ...............

9600

300

1200

2400

4800

9600

14400

19200

38400

57600

8.Select the DKAdmin/DKBackup PC COM port baud rate and press Enter. The information screen below instructs you to pull Program 03 if you changed any PCBs during the Restore process. DKAdmin/DKBackup enables you to pull Program 03 automatically.

Note If you are connected to the customer system, always have DKAdmin/DKBackup pull Program 03 when restoring data. If you are restoring data to an RCTU that is installed in a test system that is not loaded with the same PCBs as the customer database, do not pull Program 03 at this time.

DKAdmin/DKBackup will then download Program 03 and Program 76 to ensure a successful restore process.

Processor Conversion

If you added or changed any PCBs other than the RCTU PCB in the DK system, the customer database will need to be updated to reflect these changes. You can pull Program 03 from the DK to accomplish this.

If you pull Program 03 from the DK, you will override the existing customer database with the DK data.

If you do not pull Program 03 from the DK, the existing customer database will remain intact.

IMPORTANT: If you have upgraded the customer database offline, DO NOT pull Program 03 as it will override your changes.

IMPORTANT: Any time DK14/DK16e/DK40 is upgraded, Program 03 must be pulled so DKAdmin can update the new system’s cabinet drawing.

NOTE: If you pull Program 03 from the DK, the DK will be initialized with Program 91-1 automatically. This initialization program identifies the PCBs to the DK.

Press any key to Continue

Backup Menu (DKBackup) 105