Restore Data
●The DK System Program File list is displayed (see Step 3 on Page 101). If this screen does not display, the DKAdmin/DKBackup PC and the Strata DK are not communicating. See Appendix A – Connecting to Strata DK for procedures to connect the PC COM port to the Strata DK PIOU, RSSU, RSIS, RSIU, or PIOUS TTY port, or IMDU or RMDS modems.
Important! If the PC screen does not display prompts such as Turning on LED 10, Program
Restore Data
➤Prior to restoring data
1.Select a customer using the Select Customer option in the File Menu.
This should be the customer database which has been created or previously backed up using DKAdmin/DKBackup. This customer database must be the same DK Release (e.g., 1, 2, 3, or 4.X) and processor type to which you are restoring data.
Although DK16e is considered Release 1, it contains the Release 3 features of RCTUA3 with the exception of Distributed Hunt.
Note Release 3 data can be restored to Release 3.X data and vice versa.
2.Establish communications between the DKAdmin/DKBackup PC and the Strata DK using the Dial DK option or by making a direct connection (see Appendix A – Connecting to Strata DK).
3.After connecting to the Strata DK, select the Administration Menu/Backup Menu and run the Check Processor Type option to verify that the customer file format is the same as the installed Strata DK processor.
Important! Make sure the processor type, ROM/Flash release number is the same as the customer database you are restoring.
If the Problem: Unable to Establish Communications screen displays, follow the steps on the screen and/or see Appendix A – Connecting to Strata DK to correct the problem.
➤To restore (upload) a customer’s database
1.After checking the processor type, select the Administration Menu/Backup Menu and type b. The DK Code dialog displays.
2.Enter the
Important! You must enter the code that is programmed on the installed processor.
For security, this code does not display on screen as you type it. The default code is 0000. This is the “1st level password” which is set in the Strata DK system Program 00 (see the record sheet for Program 00 in the Strata DK Programming Manual).
102 | DKAdmin/DKBackup |