Zebra Technologies 7030 technical manual Eject page when new page is printed. Retract disabled

82

Default Parameter Settings

Print Setup

45	0	Default	Presenter Mode	DRV
	0	Min
	230	Max

Sets the function of the presenter. The Retract selections are only valid if a retract option is fitted.

			<ESC>&P<45><0>	Eject page when new page is printed. (Retract disabled)
			<ESC>&P<45><3>	Eject page when new page is printed. Page not taken after 30s
				will be retracted. (Range 1-30, 1 step = 10 s)
			<ESC>&P<45><100>	Retract page when new page is printed
			<ESC>&P<45><103>	Retract page when new page is printed. Page not taken after 30s
				will be retracted. (Range 101-130, 1 step = 10 s)
			<ESC>&P<45><200>	Do nothing when new page is printed. (Auto-eject and retract
				disabled).
			<ESC>&P<45><203>	Do nothing when new page is printed. Page not taken after 30s
				will be retracted. (Range 201-230, 1 step = 10 s)
	40	Default
47				Eject Calibration Constant	DRV
	0	Min
	255	Max

Sets the eject length of the printout, that is the length of paper that protrudes outside the printer after a cut command. This eject length should be 40-63 mm. Marks on the test printout show max and min eject length.

The default value when loading firmware is 40, but should be set individually from printer to printer. The set value is shown in a line on the test printout.

After sending the command, store the parameters, and wait until the presenter motor buzzes. Then make a self test printout to check if the set eject length is correct.

Example • This example sets parameter 47 to 50 and stores the parameters as default settings

<ESC>&P<47><50> <ESC>&<4>

P1003636-002 TTP 7030™ Technical Manual 10/05/2009