104
Maintenance
Firmware
Firmware
The firmware is stored in
Please visit our web site http://www.zebra.com for the most current firmware versions.
Loading
Note • We recommend you to design your kiosk system so that remote upgrade of firmware is possible. If you need to upgrade firmware in the future, the kiosks can be spread over a vast area and upgrade can become very expensive.
Download the most current firmware version from the Zebra web site http://www.zebra.com. There you will also find the Toolbox utility program (Windows™ software) facilitating the loading of the firmware into the printer.
Are you using a Windows environment to load the firmware?
If… | Then… | |
|
|
|
No | a. | Send <ESC><NUL> (1BH 00H) to the printer. |
| b. | Wait 0.5 seconds. |
| c. | Send the firmware file to the printer. |
| d. Wait until the printer buzzes to confirm that the loading is complete (the | |
|
| presenter motor runs for a second). |
|
| |
Yes | The loader program contains a help file with detailed instructions on how to | |
| load the firmware into the printer. | |
|
|
|
Important • The loading and burning can take up to one minute. Do not abort before one minute by turning OFF the power to the printer. Doing so may leave the printer in a state where new firmware cannot be loaded. If this occurs, please return the printer to a Zebra authorized service provider.
Functions and features are being added from time to time, affecting the firmware in the printer. The following table lists the changes of general interest. The firmware number is divided into two sections, the header and the version, separated by a dash.
Printer | Barcode support | Firmware header |
|
|
|
TTP 7030 | 1D barcodes |
|
|
|
|
TTP 7030 | 2D |
|
|
|
|
A printer can only be updated with firmware that has the same header as the original number. The
Note • Specification subject to changes without notice.
| TTP 7030™ Technical Manual | 10/05/2009 |
