Zebra Technologies 7030 technical manual CR = Ignored, LF = Ignored, On the paper, No cut, Normal

78

Default Parameter Settings

Print Setup

33	0	Default	CR/LF Behavior*
	0	Min
	4	Max

*.		v=0 is suitable for Windows, v=1 for UNIX, v=2 for DOS, and v=4 for Macintosh
				Carriage Return and Line Feed can be interpreted in five different ways to suit different
				operating systems.
				<ESC>&P<33><0>			LF = CR/LF	CR = Ignored
				<ESC>&P<33><1>			LF = CR/LF	CR = CR
				<ESC>&P<33><2>			LF = LF	CR = CR
				<ESC>&P<33><3>			LF = LF	CR = CR/LF
				<ESC>&P<33><4>			LF = Ignored	CR = CR/LF
				Note • The character currently interpreted as LF converts text from the input buffer to pixels
				on the paper.
	1		Default
34					Auto Cut After FF
	0		Min
	2		Max
				Decides if the printer should cut after executing an FF command, or if it should just feed the
				form length.
				<ESC>&P<34><0>	No cut
				<ESC>&P<34><1>	Cut
				<ESC>&P<34><2>	Forced cut at black mark (cuts directly when a black mark is
					detected). This works only if black mark mode is selected
					(n36=2).
		0	Default
35						Black Mark Mode
		0	Min
		1	Max
				When enabled, marks on the paper set the form length. Minimum one form length is always
				fed. If a black mark is found before that, the printer feeds to the next black mark, then cuts and
				ejects. This ensures that no small paper stripes are cut of and left in the printer. Note that this
				parameter is used when loading paper and when pressing the Feed button. So even if black
				mark is enabled in the Windows driver and works, parameters for black mark must be set up
				correctly.
				<ESC>&P<35><0>		Normal
				<ESC>&P<35><1>		Black mark synchronization enabled

P1003636-002 TTP 7030™ Technical Manual 10/05/2009