Zebra Technologies 7030 Sets max black mark length to 5 mm, Sets min black mark length to 4 mm

				Default Parameter Settings
				Print Setup
	80	Default
39			BM (Black Mark) Length		DRV
	16	Min
	160	Max

Specifies the length of the black mark in 0.125-mm steps. Measure the length of the black mark on your paper and enter that value here.

Marks 5 mm longer than this value are interpreted as paper out. The default value of 80 equals 10 mm.

81

<ESC>&P<39><40>

Sets max black mark length to 5 mm.

40	24	Default	Min BM (Black Mark) Length “Mark Filter”	DRV
	15	Min
	159	Max

This parameter specifies the minimum length of the black mark in 0.125 mm increments. Shorter marks are ignored. The default value of 24 equals 3 mm. This filters out pre-print or marks on the paper. If the mark is smaller than the value set for this parameter, it will not be regarded as a TOF black mark. A value equal to 1/3 the length of a TOF black mark is usually the most effective.

<ESC>&P<40><36>

Sets min black mark length to 4 mm.

41 & 42	0	, 0	Default	BM (Black Mark) Cut Offset	DRV
	0	, 0	Min
	255	, 255	Max

Defines the paper feed between the black mark detection and cut. One step is 0.125 mm.

<ESC>&P<41><1><ESC>&P<42><144>

Feeds 50 mm between black mark and cut.

43 & 44	0	, 0	Default	Top Margin
	0	, 0	Min
	255	, 255	Max

Defines the distance between the top of the paper and the top of the first text line in 0.125 mm steps. The top margin feed is effectuated when the presenter is cleared from the previous page.

0 =

disabled top margin. This gives the physical top margin of the printer, which is 17 mm.

Avoid settings 1 – 16 mm because then the printer must reverse the paper before starting to print, which may cause paper jam, especially at small roll diameters.

<ESC>&P<43><0><ESC>&P<44><240>

Add 30-mm top margin.

10/05/2009 TTP 7030™ Technical Manual P1003636-002