Remote Control Operation
Initial Use*
*When purchased the remote control
has a battery installed with a plastic insert to prevent battery discharge. Remove the plastic insert before attempting to use the remote.
Battery Replacement
1.Remove the battery holder. Refer to the drawing.
2.Insert the battery into the battery holder and insert the battery holder into the remote. Be sure to observe the correct polarity
3.For best results, aim the remote directly at the remote receiver window within 10 feet, and angles not exceeding 60 degrees.
4.The path between the remote control and remote sensor should be free of obstructions.
5.Under normal use the battery will last for approximately one year.
6
6.Remove the battery if the remote is not going to be used for a long time or during storage. The remote control will only operate the MMD92. It is not a universal remote control and will not control equipment from other manufacturers.
MMD92
1287962 user manual | 6 | 6/15/2007, 1:27 PM |