Sharp GX-M10H(OR), GX-M10H(RD) operation manual Remote control, Carrying the unit, Placing the unit

■Connecting iPod or iPhone to TV

Photo and video files from iPod or iPhone can be viewed by connecting the system to TV/monitor.

If the TV/monitor has a video input, connect it to the VIDEO OUT socket at the back of the unit and set the TV Out on the iPod or iPhone unit to “ON” position.

Note:

Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple’s homepage for further information.

Remote control

■Battery installation

1Open the battery cover.

2Insert the supplied battery according to the terminal indicated in the battery compartment.

When inserting or removing the battery, push it towards the

(–) battery terminals.

3Close the cover.

Caution:

●Remove the battery if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.

●Do not use rechargeable battery (nickel-cadmium battery, etc.).

●Installing the battery incorrectly may cause the unit to malfunction.

●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

Notes concerning use:

●Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase an “AA” size battery (UM/SUM-3, R6, HP-7 or similar).

●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.

●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

●Keep the remote control away from moisture, heat, shock, and vibrations.

■Test of the remote control

Check the remote control after checking all the connections. Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below:

Carrying the unit

Caution:

Before transporting the unit, remove the iPod, iPhone, iPad, USB memory device and disc from the unit. Then, set the unit to the power stand-by mode. Transporting the unit with iPod, iPhone, iPad or USB memory device left connected or discs left inside might damage the unit.

■Using the carrying strap

This unit can be carried by using a supplied carrying strap. Insert the carrying strap carabiner (hook) to each end of the unit as shown below.

Carabiner (hook)

Hole

To remove the carrying strap

Hole

Caution:

Before carrying the unit, make sure the carabiner (hook) is properly secured and closed, otherwise it will cause damage and injury.

Placing the unit

This unit can be placed in 2 positions as shown below.

Caution:

●Make sure that the unit is placed on a flat and level surface.

●Make sure to turn the unit carefully when adjusting the position.

●Do not place the unit other than these 2 positions to avoid damage and injury.

To get the best display viewing angle, place the unit as below.

Position 1:

On the shelf/table.

Foot cushion 1 and 2 touching the surface.

Remote sensor	Position 2:
	On the floor/ground

0.2 m - 6 m (8" - 20' )

Foot cushion 2 and 3 touching the surface.

Note:

Exposing the infrared remote control to direct sunlight may cause the remote control to be inoperable.

E-5

12/10/26 12_GX-M10H_OM_EN.fm