Sharp GX-M10H(RD), GX-M10H(OR) Troubleshooting chart, Sleep operation, CD player, Tuner

Timer and sleep operation (Remote control only) (continued)

Reusing the memorised timer setting:

The timer setting will be memorised once it is entered. To reuse the same setting, perform the following operations.

Troubleshooting chart

Many potential problems can be resolved by the owner without calling a service technician.

If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre.

1 Turn the power on and press and hold down the CLOCK/TIMER button.

2Within 10 seconds, press the or button to select “ONCE” or “DAILY”, and press the ENTER button.

3Within 10 seconds, press the or button to select “TIM.ON” , and press the ENTER button.

4Press the ON/STAND-BY button to enter the power stand-by mode.

■Sleep operation

The radio, compact disc, iPod, USB, and Audio In function can all be turned off automatically.

1Play back the desired sound source.

2Press the SLEEP button.

3Within 5 seconds, press the Numeric button to set the time. (1 minute ~ 99 minutes)

4“SLEEP” will appear.

5The unit will enter the power stand-by mode automatically after the preset time has elapsed. The volume will be turned down 1 minute before the sleep operation finishes.

To confirm the remaining sleep time:

1Whilst “SLEEP” is indicated, press the SLEEP button.

To cancel the sleep operation:

Press the ON/STAND-BY button whilst “SLEEP” is indicated. To cancel the sleep operation without setting the unit to the stand-by mode, proceed as follows.

1Whilst “SLEEP” is indicated, press the SLEEP button.

2Within 5 seconds, press the “0” button twice until “SLEEP 00” appears.

■To use timer and sleep operation together

Sleep and timer playback:

For example, you can fall asleep listening to the radio and wake up to CD in the next morning.

1Set the sleep time (see above, steps 1 - 5).

2Whilst the sleep timer is set, set the timer playback (steps 2 - 9, page 19).

■ General
Symptom	Possible cause
● The clock is not set	● A power failure occured.
to the correct time.	Reset the clock. (Refer
	page 6)
● When a button is	● Set the unit to the power
pressed, the unit	stand-by mode and then
does not respond.	turn it back on.
	● If the unit still malfunctions,
	reset it. (Refer page 21)
● No sound is heard.	● The volume level is set to
	“MIN”.
	● The headphones are
	connected.
● Sound too low or	● The batteries are depleted.
distorted.	Change the batteries.
● Power suddenly
shuts down.

■ CD player

Symptom	Possible cause
● Playback does not	● The disc is loaded upside
start.	down.
● Playback stops in	● The disc does not satisfy
the middle or is not	the standards.
performed properly.	● The disc is distorted or
	scratched.
● Playback sounds are	● The unit is located near
skipped, or stopped	excessive vibrations.
in the middle of a	● A very dirty disc has been
track.	used.
	● Condensation has formed
	inside the unit.
	● Volume level is too high.
	Adjust to lower volume.

■Remote control

Symptom	Possible cause
● The remote control	● The AC power lead of the
does not operate.	unit is not plugged in.
	● Wrong battery polarity.
	● The batteries are
	exhausted.
	● The distance or angle is
	incorrect.
	● The remote control sensor
	receives strong light or
	sunlight.

Sleep timer		Timer playback		End
setting		setting		time
	1-99 minutes			Desired time
	Sleep operation will		Timer playback
	automatically stop		start time

■Tuner

Symptom Possible cause

●The radio makes ● The unit is placed near the

unusual noises	TV or computer.
continuously.	● The FM aerial is not
	properly extended or
	positioned.

EN

E-20

12/10/26 12_GX-M10H_OM_EN.fm