Elo TouchSystems touch monitor manual Installing the Touch Driver for MS-DOS Windows

Page 16

Installing the Touch Driver for MS-DOS and

Windows 3.1

You must have a DOS mouse driver (MOUSE.COM) installed for your mouse if you wish to continue using your mouse along with your touchmonitor in DOS.

To install Windows 3.x and MS-DOS from Windows 95/98, follow the directions below:

1Insert the Elo CD-ROM in your computer’s CD-ROM drive.

2From DOS, type d:\EloDos_W31 to change to the correct directory on the CD-ROM (your CD-ROM drive may be mapped to a different drive letter).

3Type install and press Enter to start the installation.

4Align the touchscreen.

You must have already completed Steps 1 and 2 before proceeding. Refer to Chapter 2 of the Elo DOS and Windows Driver Guide as necessary for additional installation information.

To run the INSTALL program:

1Type INSTALL at the DOS prompt in the directory containing the driver install files.

2INSTALL asks you to select the software to install. Then choose d:\EloDos_W31 from the displayed list.

3INSTALL also asks you for the paths to use during installation, or you may use its defaults. INSTALL creates directories as necessary, and warns you if they exist.

If you are updating your software, you may wish to specify the paths containing the earlier versions, and overwrite the obsolete files. All executable programs are upward compatible. For a list of differences from each previous version of the drivers, be sure to select "Differences from Previous Versions" during the installation process.

INSTALL updates your AUTOEXEC.BAT file with the drivers you select. INSTALL makes a copy of your original AUTOEXEC.BAT file, called AUTOEXEC.OLD. If you already have Elo driver commands in your AUTOEXEC.BAT file, they will be commented out.

When INSTALL is finished, it leaves a file called GO.BAT in the subdirectory you specified. GO loads the touchscreen driver, runs the calibration program ELOCALIB, and gives you some final instructions.

If you are using Windows 3.1, you will also calibrate the touchscreen within Windows 3.1 with the Touchscreen Control Panel.

2-9

Image 16
Contents Page Elo Entuitive Touchmonitor User Guide Page Copyright 2003 Elo TouchSystems Inc. All Rights Reserved Page Table of Contents Page Precautions About the ProductRS-232 touch interface Installation and Setup Unpacking Your TouchmonitorConnecting Your Touchmonitor Connect the Video CableConnect the Serial Touchscreen Cable Connect the Power Cable Installing the Driver Software Page Installing the Touch Driver for MS-DOS Windows Page About Touchmonitor Adjustments OperationUsing the On Screen Display OSD Touchmonitor ControlsOSD Adjustments Position, V. Position Timeout CorrectMoire RotationBrightness DegaussContrast 9300 Troubleshooting Problem Suggestion sProblem Suggestion s Touch Technology Touchscreens An OverviewITouch Touchscreens Touchmonitor Safety Page 19Monitor Touchmonitor SpecificationsMonitor EMC Optical MechanicalEnvironmental Signal Pinout for 15,17 and 19 Monitors PIN Number SignalPower Consumption Monitor ModePower Monitor Power ModePreset Timing Table Horizontal Resolution Frequency Refresh RateRegulatory Information E141667DHHS Warranty Page Index