Elo TouchSystems touch monitor manual E141667DHHS

Page 37

1)In order to meet emission and immunity requirements, the user must observe the following:

a)Use only the provided I/O cables to connect this digital device with any computer.

b)To ensure compliance, use only the provided manufacturer-approved line cord.

c)The user is cautioned that changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

2)If this equipment appears to cause interference with radio or television reception, or any other device:

a)Verify as an emission source by turning the equipment off and on.

b)If you determine that this equipment is causing the interference, try to correct the interference by using one or more of the following measures:

i)Move the digital device away from the affected receiver.

ii)Reposition (turn) the digital device with respect to the affected receiver.

iii)Reorient the affected receiver’s antenna.

iv)Plug the digital device into a different AC outlet so the digital device and the receiver are on different branch circuits.

v)Disconnect and remove any I/O cables that the digital device does not use. (Unterminated I/O cables are a potential source of high RF emission levels.)

vi)Plug the digital device into only a grounded outlet receptacle. Do not use AC adapter plugs. (Removing or cutting the line cord ground may increase RF emission levels and may also present a lethal shock hazard to the user.)

If you need additional help, consult your dealer, manufacturer, or an experienced radio or television technician

E141667DHHS

30 E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e

Image 37
Contents Page Elo Entuitive Touchmonitor User Guide Page Copyright 2003 Elo TouchSystems Inc. All Rights Reserved Page Table of Contents Page About the Product PrecautionsRS-232 touch interface Unpacking Your Touchmonitor Installation and SetupConnect the Video Cable Connecting Your TouchmonitorConnect the Serial Touchscreen Cable Connect the Power Cable Installing the Driver Software Page Installing the Touch Driver for MS-DOS Windows Page Operation About Touchmonitor AdjustmentsTouchmonitor Controls Using the On Screen Display OSDOSD Adjustments Correct Position, V. Position TimeoutMoire RotationBrightness DegaussContrast 9300 Problem Suggestion s TroubleshootingProblem Suggestion s Touchscreens An Overview Touch TechnologyITouch Touchscreens Touchmonitor Safety Page 19Monitor Touchmonitor SpecificationsMonitor EMC Optical MechanicalEnvironmental PIN Number Signal Signal Pinout for 15,17 and 19 MonitorsMonitor Mode Power ConsumptionPower Monitor Power ModeHorizontal Resolution Frequency Refresh Rate Preset Timing TableRegulatory Information E141667DHHS Warranty Page Index