| |
STATION: | 1 |
FREQ: | 101.70 MHz |
MODE: | MANUAL |
INPUT STATION
It also appears on the VFD:
INPUT
When the digit 1 pressed, OSD appears:
| ||
STATION: | 1 |
|
FREQ: | 101.70 MHz | |
MODE: | MANUAL | |
SAVE | TO | 1 |
|
|
|
Also the VFD appears:
| SAVE | TO | 1 |
|
|
|
|
| |
After a while, OSD appears: |
|
| ||
|
|
|
| |
|
|
| ||
| STATION: |
| 1 |
|
| FREQ: |
| 101.70 MHz |
|
| MODE: |
| MANUAL |
|
|
|
|
|
|
And VFD appears:
FM 1 | 101.7 M |
|
|
Press again the FREQ goes up higher frequency. The program of the frequency spotted goes to broadcast. With the same way above go on to do the next frequency searching. To get an optimum of receiving broadcast you can press or for a fine frequency adjustment of the program broadcasting, and the result of which can be kept by pressing ENTER/PLAY on the remote control.
After saving you can run any digit of 1~20, in each of which one FREQ frequency broadcasting has been saved, to listen to the broadcast of the FM frequencies corresponding with what you have ever saved.
Press (NEXT) or (PREVIOUS) turns in next higher or previous lower FREQ station.
NOTES:
You can save up to 20 frequencies.
Machine will save the frequencies for later use.
VFD of the machine will display the saved message being played when the TUNER is on.
The FM frequency range: 87.5 – 108MHz
For a good reception the FM antenna is required and that have to be put in an optimum location.
RDS PS FUNCTION (Radio Data System Program Service station name)
The name of the RDS station now being received instead of the frequency will display on the VFD. e.g.: BBC R3
NOTE:
This function can be used under Tuner mode only.
30