Elo TouchSystems 2201L General Mounting Information, Rear Vesa Mount, Stand Mounting

Page 10

Chapter 3 – Mounting

General Mounting Information

The OSD text can be rotated through the OSD menu to better suit your mounting orientation.

The holes located on the sides and top of the touchmonitor case are for ventilation. Do not block, cover, or insert anything inside the ventilation slots.

Rear VESA Mount

A four-hole 100x100mm mounting pattern for M4 screws is provided on the rear of the monitor. Remove the stand using a Phillips screwdriver to access this mounting interface. The VESA FDMI-compliant mounting is coded: VESA MIS-D, 100, C

Stand Mounting

Threaded through-holes are provided on the bottom of the stand base for mounting or securing.

User Manual – 2201L

SW601363 Rev B - Page 10 of 22

Image 10

Contents 2201L Touchmonitor Copyright 2011 Tyco Electronics. All Rights Reserved Table of Contents Introduction PrecautionsProduct Description Connector Panel & Interfaces InstallationUnpacking the Touchmonitor Touchmonitor Connections Installing the Touch Technology Software Drivers SW601363 Rev B Page 8 SW601363 Rev B Page 9 Rear Vesa Mount MountingGeneral Mounting Information Stand MountingTouch PowerOperation VideoPhase On-Screen Display OSDOSD OSD and Power Lockouts AudioTechnical Support Solutions to Common ProblemsTechnical Assistance Safety Safety & MaintenanceCare and Handling Waste Electrical & Electronic Equipment Directive Weee Regulatory Information PBB SW601363 Rev B Page 20 Warranty Information Check out Elo’s Website