Elo TouchSystems 2201L user manual Touchmonitor Connections

Page 6

Touchmonitor Connections

1.Connect the DVI or VGA video cables between the monitor’s DVI/VGA input connectors and your DVI/VGA video source, respectively. Tighten the video cable’s screws for best performance.

2.Connect the USB touch cable between the monitor’s USB connector and your PC’s USB port.

3.Connect the audio cable between the monitor’s Audio In jack and your audio source.

4.Select the correct power cable for your region. Connect the cable between the AC power source and the power adapter’s input connector. Connect the power adapter’s DC output connector to the monitor’s input power jack.

5.Replace the cable cover, if desired. Cables can be routed inside the stand – remove and replace the stand cable cover for access and routing.

6. The touchmonitor ships in an OFF state. Press the power button to turn it on.

User Manual – 2201L

SW601363 Rev B - Page 6 of 22

Page 5 Page 7
Image 6
Page 5 Page 7
Contents 2201L Touchmonitor Copyright 2011 Tyco Electronics. All Rights Reserved Table of Contents Precautions IntroductionProduct Description Installation Connector Panel & InterfacesUnpacking the Touchmonitor Touchmonitor Connections Installing the Touch Technology Software Drivers SW601363 Rev B Page 8 SW601363 Rev B Page 9 Rear Vesa Mount MountingGeneral Mounting Information Stand MountingTouch PowerOperation VideoPhase On-Screen Display OSDOSD OSD and Power Lockouts AudioSolutions to Common Problems Technical SupportTechnical Assistance Safety & Maintenance SafetyCare and Handling Waste Electrical & Electronic Equipment Directive Weee Regulatory Information PBB SW601363 Rev B Page 20 Warranty Information Check out Elo’s Website
Top Page Image Contents