Elite VRVD640G manual Basic Operations

Page 14

Basic Operations

Driving a vehicle while viewing a video on this head unit may violate motor vehicle laws, and may result in serious injury, property damage, or death!

To play a video the vehcle must be stopped and the parking brake must be engaged.

Install the face Plate

1)Fit the face plate with its left hole on the left pin provided on the main unit.

2)Fit the other hole on the other pin apply- ing slight pressure

3)Move the face plate up and down a few times to make sure it is secure. Then close the face plate and press down the right side of the face plate until it clicks into plate.

Caution

• This face plate is not waterproof. Do not expose it to water or excessive moisture,

• Do not remove the face plate while driv- ing your car.

• Do not place the face plate on the dash- board or nearby areas where the tempera- ture rises high.

• Do not touch the contacts on the face plate and the main unit, since this may re- sult poor electrical contact.

• If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth.

• To avoid damaging the face plate, do not push it down or place objects on it while it is open.

Starting The Unit For the First Time Immediately after installing or connecting power to the unit, it should be initialized. Lower the detachable front panel. Behind the front panel, is a small hole with the re- set switch in it. With a ball-point pen or oth- er pointed object, press the RESET switch to initialize the unit.

Power/Mute Button

Press any button to turn the unit ON. The Radio is the default function at start-up. Press and Hold the Power button to turn the unit OFF.

Press to mute the radio, CD/DVD, USB and SD card operations.

OPEN/CLOSE Button

When power is OFF, press the Open but- ton, the unit turns ON and the panel opens for access to the Disc slot.

If the panel’s movement is hindered by any obstacle, it will return to original its closed position automatically.

Mode Button

Pressing the Mode button will cycle through the different functions. The DVD, USB, and SD will not be accessed if there is no me- dia installed.

TUNER--DVD--USB--SD--AV--MAIN MENU

Menu Button

Press Menu button to enter main menu.

Band Button

There are four Pre-set Bands - three FM (FM1, FM2, and FM3) and two AM Bands(AM1, AM2). Each time the button is pressed, the radio band changes in the following order:

FM1----FM2----FM3----AM1----AM2

Each of the four bands can store up to six preset stations, for a total of 30 (18-FM,12- AM) pre-set memory stations.

EJECT Button

Eject the disc. If the disc is not removed after 10 seconds after it’s ejected, the disc is automatically re-loaded and will start to play.

Tune -/Left Arrow

Use this button to tune the receiver to a lower frequency.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents WMA DVD VCD CD-R CD-RW ID3 Welcome Contents Page Precautions Disc & Memory Types Disc Type Icon Content Size PlaytimeMemory Type Icon Content Size Playtime Care of DiscsRemove the Old Unit from the Dashboard InstallationMark Polarity of the Speaker Wires DIN FRONT-MOUNT Method a DIN REAR-MOUNT Method B Check All Included PartsWiring Connections VRVD640GLocation Of The Controls Audio/Video Auxiliary InputPrecautions Remote ControlChanging the Battery Use and Care of the RemoteVolume Down PowerSetup Volume UPBasic Operations PTY Main Menu Main Menu Screen Settings Menu ScreenSound Settings RDS & Radio Settings Display SettingsDate & Time Settings Menu ScreensUtil Utility Control Screen System InformationCalibration Screen Control FunctionRadio Mode Radio Operations Retune Mode Radio ModeRegional Mode Mask ModeFile List Screen Multimedia ModeTouch Screen Ejecting a DiscStop Pausing Playback on DVDPlayback Skip Backwards/Fast RevGO to Multimedia Mode ModeProgram Navigation System Virtual keyboards SwitchesSwitches in the Quick menu ABC-Type KeyboardsAbout screen Discovering the program through the screensMain menu GPS Data screenTime Synchronization GPS Connection IndicatorGPS Data Quality Indicator MapChanging the Scale of the Map 2D and 3D Map ViewsZoom Levels Daylight and Night Color SchemesStreets and Roads LandmarksVisible POIs Points of Interest Selected Map PointCursorMarked Map Points Pin Active Leg Of The Route Elements of the Active RouteAnimated Turn Guidance Inactive Legs Of The RouteCockpit Screen Next Street / Next City NoTrack Log Recording/Playback Indica- tor No GPS Position Quality NoSound Muting No Cursor NoCursor menu No Menu No Current Street NoTilt Up And Down No Travel and Route Data NoMap Scale Distance to Next Turn NoApproaching Next Turn No Route Information ScreenTime Left Distance LeftMethod Estimated ArrivalNight Mode switch 3D Map switchZoom & Tilt switch Fit To ScreenManage My POI Manage POI Points of InterestManage Built-In POI Visibility Manage Track Logs Recalculate CancelRoute Tab Bypass Drop Next Via Point / Delete RouteAvoid Display ModesShow Fly OverSettings Speeding Tolerance Warn When SpeedingAutomatic Night Colors Alternative Speed LimitMAP Settings Sound Settings Route Parameter Settings Language & Units Display Options Advanced Settings2D in Map mode and North-up orientation Zoom In After FindBacklight Settings Smart Zoom SettingsDelay Before Restoring Restore Lock-to-PositionRestore Smart Zoom Route OptionsTurn Penalty Recalculation DelayOff-route Sensitivity Cross-Border PlanningRemove Pins Backup DataRestore Data Reset Advanced SettingsSearch Using the Find MenuSelecting the City, State or Country to Selecting a New City To SearchNavigation System Selecting a Street Or The Center Of The City How To Select An Intersection Instead Of a House NumberChanging The Country Selecting The Center Of The CityFind in History Find CoordinatesFind a POI Navigation System Frequently Asked Questions Would like to create a new POI durGlossary GlossaryGlossary Glossary Specifications TFT Monitor AudioVideo License of MacrovisionPage Limited Warranty Conditions of Warranty
Top Page Image Contents