Elite VRVD640G Off-route Sensitivity, Recalculation Delay, Turn Penalty, Cross-Border Planning

Page 52

Navigation System

vice, the GPS antenna location in the car and the environment you are driving in, route recalculation can behave differently. Cydle may think you have departed the proposed route and perform a recalcula- tion even if you have not done so.

When the GPS reception is poor (e.g. driv- ing in an urban environment with a low sen- sitivity GPS), occasional wandering (called position fluctuation) of the calculated GPS position is likely. Although Cydle employs

asophisticated Lock-on-Road system that will mostly suppress these position errors by aligning your position to the recom- mended route and the road network of the map, sometimes the errors are too large to correct.

To reduce the effect of large errors, you can increase the recalculation tolerance two ways.

Off-route Sensitivity

This is a range of relative values from 0 to 10, telling Cydle how far the GPS position should be from the recommended route before the program decides to recalculate. Lower values make Cydle insensitive to position errors; higher values will result in quicker reactions.

Recalculation Delay

This is a setting that helps suppress the effects of position fluctuation. With a few seconds delay in recalculation even large position jumps can be survived without a need for route recalculation.

U-Turn Penalty

You can fine-tune the way Cydle takes U- turns into account when planning a route. You can tell Cydle how much extra distance you would travel to avoid a U-turn.

NOTE: This value is taken into account only if U-turns are enabled in Route Param- eters.

Cross-Border Planning

By default Cydle plans routes using the border crossing points. However, if you live near the border, you can disable border crossing with this switch to remain within one country.

Keep Position On Road (Lock-on-road) Cydle is normally used for vehicle naviga- tion, therefore Lock-on-Road will display the position arrow precisely over roads, seamlessly correcting small GPS errors. For pedestrian use you may consider disabling Lock-on-Road to make Cydle always show your exact position.

NOTE: By turning off Lock-on-Road you also turn off the GPS position error filtering. The position shown on the map will be subject to all position errors and position fluctuations.

USER DATA MANAGEMENT

Everything that was saved (pins, My POIs, Favourites, track logs etc.) or modified (Settings, History lists) since Cydle was in- stalled is stored in a user database located in the internal memory of the PNA. Here you have options to save, restore or reset the database or parts of it.

52

Image 52
Contents WMA DVD VCD CD-R CD-RW ID3 Welcome Contents Page Precautions Disc Type Icon Content Size Playtime Memory Type Icon Content Size PlaytimeDisc & Memory Types Care of DiscsMark Polarity of the Speaker Wires InstallationRemove the Old Unit from the Dashboard DIN FRONT-MOUNT Method a DIN REAR-MOUNT Method B Check All Included PartsWiring Connections VRVD640GLocation Of The Controls Audio/Video Auxiliary InputRemote Control Changing the BatteryPrecautions Use and Care of the RemotePower SetupVolume Down Volume UPBasic Operations PTY Sound Settings Main Menu Screen Settings Menu ScreenMain Menu Display Settings Date & Time SettingsRDS & Radio Settings Menu ScreensSystem Information Calibration ScreenUtil Utility Control Screen Control FunctionRadio Mode Radio Operations Radio Mode Regional ModeRetune Mode Mask ModeMultimedia Mode Touch ScreenFile List Screen Ejecting a DiscPausing Playback on DVD PlaybackStop Skip Backwards/Fast RevProgram Multimedia Mode ModeGO to Navigation System Switches Switches in the Quick menuVirtual keyboards ABC-Type KeyboardsDiscovering the program through the screens Main menuAbout screen GPS Data screenGPS Connection Indicator GPS Data Quality IndicatorTime Synchronization Map2D and 3D Map Views Zoom LevelsChanging the Scale of the Map Daylight and Night Color SchemesStreets and Roads LandmarksMarked Map Points Pin Selected Map PointCursorVisible POIs Points of Interest Elements of the Active Route Animated Turn GuidanceActive Leg Of The Route Inactive Legs Of The RouteCockpit Screen Next Street / Next City NoGPS Position Quality No Sound Muting NoTrack Log Recording/Playback Indica- tor No Cursor NoCursor menu No Current Street No Tilt Up And Down NoMenu No Travel and Route Data NoDistance to Next Turn No Approaching Next Turn NoMap Scale Route Information ScreenDistance Left MethodTime Left Estimated Arrival3D Map switch Zoom & Tilt switchNight Mode switch Fit To ScreenManage Built-In POI Visibility Manage POI Points of InterestManage My POI Manage Track Logs Cancel Route Tab BypassRecalculate Drop Next Via Point / Delete RouteDisplay Modes ShowAvoid Fly OverSettings Warn When Speeding Automatic Night ColorsSpeeding Tolerance Alternative Speed LimitMAP Settings Sound Settings Route Parameter Settings Language & Units Advanced Settings 2D in Map mode and North-up orientationDisplay Options Zoom In After FindBacklight Settings Smart Zoom SettingsRestore Lock-to-Position Restore Smart ZoomDelay Before Restoring Route OptionsRecalculation Delay Off-route SensitivityTurn Penalty Cross-Border PlanningBackup Data Restore DataRemove Pins Reset Advanced SettingsUsing the Find Menu Selecting the City, State or Country toSearch Selecting a New City To SearchNavigation System How To Select An Intersection Instead Of a House Number Changing The CountrySelecting a Street Or The Center Of The City Selecting The Center Of The CityFind in History Find CoordinatesFind a POI Navigation System Frequently Asked Questions Would like to create a new POI durGlossary GlossaryGlossary Glossary Specifications Audio VideoTFT Monitor License of MacrovisionPage Limited Warranty Conditions of Warranty