Hanns.G TFT LCD Monitor user manual Technical Support FAQ, For General Defective

Page 17

User’s Manual

TECHNICAL SUPPORT (FAQ)

Q & A FOR GENERAL DEFECTIVE

PROBLEM & QUESTION

POSSIBLE SOLUTION

Power LED is not on

*Check if the Power Switch is in the ON position

*Power Cord should be connected

 

 

*Check if the PC system is Plug & Play compatible

No Plug & Play

*Check if the Video Card is Plug & Play compatible

 

*Check if the D-15 plug pin of Video Cable is bent

Picture is fuzzy

*Adjust the Contrast and Brightness Controls.

Picture bounces or a wave

*Move electrical devices that may cause electrical

pattern is present in the

interference.

picture

 

 

*Computer Power Switch should be in the ON position.

 

*Computer Video Card should be snugly seated in its slot

 

*Make sure monitor’s video cable is properly connected

The power LED is ON

to the computer.

*Inspect monitor’s video cable and make sure none of

(orange) but there’s no

the pins are bent.

video or no picture.

*Make sure computer is operational by hitting the CAPS

 

 

LOCK key on the keyboard while observing the CAPS

 

LOCK LED. The LED should either turn ON or OFF after

 

hitting the CAPS LOCK key.

Missing one of the primary

*Inspect the monitor’s video cable and make sure that

colors (RED, GREEN, or

none of the pins are bent.

BLUE)

 

Screen image is not centered

*Adjust pixel frequency CLOCK and FOCUS or press

or sized properly.

hot-key (AUTO)

 

 

Picture has color defects

*Adjust RGB color or select color temperature

(white does not look white)

 

 

 

Horizontal or vertical

*Use win 95/98/2000/NT/ME/XP shut-down mode Adjust

disturbances on the screen

CLOCK and FOCUS or perform hot- key (AUTO).

 

 

ƒCLOCK (pixel frequency) controls the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen shows vertical stripes and the picture has not correct width.

ƒFOCUS adjusts the phase of the pixel clock signal. With a wrong phase adjustment the picture has horizontal disturbances in light picture.

ƒFor FOCUS and CLOCK adjustment use “dot-pattern” or win 95/98/2000/NT/ME/XP shut-down mode pattern.

17

Image 17
Contents Inch TFT LCD Monitor FCC Class B Radio Frequency Interference Statement Ergonomics CongratulationsEnergy EmissionsEurope Ireland Recycling InformationTable of Contents Precautions Safety NoticeSpecial Notes on LCD Monitors Before YOU Operate the Monitor FeaturesChecking the Contents of the Package Install Installation InstructionsPower Cable Connections Controls and ConnectorsFigure.3. monitor’s angle Adjusting the Viewing AngleGeneral Instructions Operating InstructionsPower Indicator Power ButtonVolume Auto Adjust buttonOSD Diagram OSD Description Brightness/Contrast adjustment HOW to Adjust a SettingImage Control ColorOther Plug and PlayUser’s Manual For General Defective Technical Support FAQƒ Cable not Connected Error Message & Possible Solution