Boston Acoustics GT-50 Setup Tuning-Subwoofers, Subwoofer Level Control Subwoofer Mode Switch

Page 14

Setup Tuning—Full-Range Speakers (cont.)

8) FRONT and REAR “Q” Controls

Once the FRONT highpass crossover point has been determined, use the FRONT “Q” control to increase the bass information centered around the crossover point.

Setting the front “Q” control is done in conjunction with setting the levels on the input sensitivity and highpass crossover frequency controls. You may find while setting the “Q” that bottoming may be detected in the front speakers; lowering the “Q” input sensitivity or raising the highpass crossover point will eliminate this. Minor adjustments to each setting are required to fine-tune the system.

Setting the “Q” is a subtle process. It is recommended that the “Q” setting be left in the 0.7 position and adjusted only after the input sensitivity and highpass crossover ranges are known. Small adjustments to the “Q” setting are all that are required to fine-tune the system.

9) REAR Input Sensitivity and Crossover Controls

Setting levels for the rear channels proceeds the same as for the front except for the elimination of the “Q” control settings. Crossover selector switch must be set to “HP” and filter switch must be set to “ON.” If the loudspeaker being used is capable of full-range operation, filter should be set to “OFF.”

OFFON

SUBWOOFER LEVEL

LOWPASS

OFF 12dB 24dB

3 5 0

2 0 0

Hz

5 0

Setup Tuning—Subwoofers

1) SUBWOOFER LEVEL Control

Refer to subwoofer level control in owner’s manual. If the control is not used, SUBWOOFER LEVEL switch must be set to “OFF.”

2) SUBWOOFER Mode Switch

Move switch to left position (STEREO L-R) when used with L&R subwoofer RCA outputs. Move switch to mid- dle position (MONO L) when used with single subwoofer RCA outputs. Move switch to right position when subwoofer signal is to be derived from front and rear channels.

14

Image 14
Contents Channel, High-Current/High-Power Amplifier GT-50Table of Contents Parts List Features and SpecificationsFRONT, REAR, and Subwoofer Remote Inputs Control FunctionsFront RCA Inputs FRONT, REAR, and Subwoofer Input Sensitivity ControlsFront and Rear Q Controls Rear Input SwitchSubwoofer Mode Switch Rear RCA InputsMechanical Functions Upper side vent lower side vent Amplifier Linking Wire ConnectionVents Side and Rear FusesBattery and Charging System General Installation PrecautionsBefore You Install Wire RoutingInstallation-Amplifier Mounting Choose the Mounting LocationPassenger and Trunk Compartment Mounting Installation-Fuses and WiringWire Gauge Amplifier FusesSpeaker Output Connection Power/B+ and Power/GND ConnectionRemote Input Connection Music Setup Tuning-Full-Range SpeakersMono Subwoofer Operation FRONT, REAR, and Subwoofer Sensitivity ControlsFront and Rear Input Sensitivity Controls VolumeHead Unit Front and Rear Crossover ControlsSetup Tuning-Subwoofers Subwoofer Level Control Subwoofer Mode SwitchSubwoofer Sensitivity Control Subwoofer Crossover ControlSystem Examples 2Ω load 2Ω SubwooferFrom processor Engine Noise from Speakers Amplifier Troubleshooting GuideStatus LEDs on Amplifier not Lit-Head Unit Source Turned on If Service Seems Necessary Contact and Warranty InformationLimited Warranty US