Blaupunkt AUSTIN CD41 manual General Operations, English, Espa

MUTE / SENS

General Operations

11DISC SELECT button

Select the desired CD in CDC (CD changer) mode.

12SC/PS button

Scan tuning. Preset scan tuning. Scan play in CD/CDC mode.

13AUD button

Audio control selector; Bass, Treble, Loudness, Balance & Fader.

14Dial

Adjusts the volume level/bass/treble/balance/fader.

Storing the station names. Select alfa-numeric charac- ters.

15Infrared Sensor (behind acrylic facia)

Permits wireless remote control of AM/FM/CD and CD changer with optional credit card style remote. See Dealer for Details.

Turning the power On/Off

Press the PWR to turn on or off the unit.

Tip

When you turn on the unit, “HELLO” will be displayed then “WELCOME” will momentarily be displayed before actual power on.

When you turn off the unit, “SEE YOU” will be displayed then “GOOD-BYE” will momentarily be displayed before actual power off.

You can edit these messages. (See “Turn on/off message edit”)

Volume Level Control and Memory

Rotate the dial to adjust the volume.

It is also possible to set the maximum volume for when the power is switched on by following the procedure explained below.

1. Turn the dial until it is set at the required volume.

Volume down

Volume up

2. Press the PWR for two or more seconds. The power will be switched off and the current volume level recorded.

Muting the sound

Press.

“MUTE ” appears on the display window.

To restore the previous volume level, press MUTE / SENS again.

Setting the Clock

The clock uses a 12-hour display system. (factory set)				ENGLISH
3.	Repeatedly press the	DISP	to display “ CLOCK 12 ”.
1.	Turn the ignition key to the ON position.
2.	Press the PWR to turn on the unit.
4.	Rotate the dial within 5 seconds to select the 12 or 24-
	hour time mode. Each time you rotate the dial, the mode
	changes or toggles as follows :
	CLOCK 24
	CLOCK 12			AIS
				Ç
5.	Repeatedly press the	DISP	to display “ CLK ADJ ”.	FRAN
	A. Press the MUTE / SENS	within 5 seconds to flash the hour digit.

B.Rotate the dial to set the hour digit.

C. Press the		MUTE / SENS to flash the minute digit.
D. Rotate the dial to set the minute digit.			ÑOL
6. Press the	DISP	momentarily to complete the Clock set-
			ESPA
ting mode.
Note
If you make no button input or dial operation in 20 seconds,
the Clock setting mode will turn off automatically.
Ignition-off Clock Recall
			ÊS
The display will illuminate showing the time and then auto-
			PORTUGU
matically shut off after 5 seconds.
Press the DISP	while the ignition switch is in the “ OFF ” posi-
tion.

E-3