Blaupunkt AUSTIN CD41 manual CD Operations, Turn on/off message edit, Demonstration mode, Tips

TUN/ TRK

TUN/ TRK

CD Operations

Turn on/off message edit

You can edit the turn on/off message and store it in memory. Following four messages (factory set) can be edit with 8 char- acters each.

Turn-on message

•MESSAGE 1 : HELLO

•MESSAGE 2 : WELCOME

Turn-off message

•	MESSAGE 3	: SEE YOU
•	MESSAGE 4	: GOOD-BYE
1.	Repeatedly press the DISP to display the “ MESSAGE ”
2.	on the display window.
	Rotate the dial to select the desired message you want
	to edit.
	MESSAGE1 ➜ MESSAGE2 ➜ MESSAGE3 ➜ MES-
3.	SAGE4
	Press the MUTE / SENS , then enter the character.

A.Rotate the dial in a clockwise direction to select the

desired characters.

( A ➜ B ➜ C ➜ . . . Z ➜ < ➜ > ➜ ∗ ➜ + ➜ ➜ - ➜ ′ ➜ /

➜0➜1➜2➜3...9➜“ ”Space )′

B. Press the to move the flashing cursor to

the next position. If you press , the flashing cursor moves to the left.

C.Repeat steps A. and B. to complete entering the en- tire message 8 characters max.

	Tip
	To erase/correct a message, press the DISP for more than
	2 seconds to clear the character and re-enter.
4.	Press the MUTE / SENS to store the message.
5.	The new message flashes.
	To return to the normal radio reception, Press DISP .

Note

If you make no button input or dial operation in 20 seconds, the message edit mode will turn off automatically.

Erasing the turn on/off message

You can erase the turn on/off message if so desired.

1.	Repeatedly press the DISP to display the MESSAGE, then
2.	rotate the dial to select the message you want to erase.
	Press the MUTE / SENS .
3.	The message flashing.
	Press the DISP for more than 2 seconds.
	Repeat steps 1. and 3. if you want to erase other mes-
4.	sage.
	To return to the normal radio reception, Press DISP .

Demonstration mode

The unit shows a demonstration of each function.

When a demonstration is finished, it begins again after 10 seconds, and this is repeated.

1.	Press the	PWR	to turn off the unit.
2.	Press the	DISP	and 1 simultaneously for more than 2

seconds to activate the demonstration mode.

Press both button again for more than 2 seconds to can- cel this mode.

Playing the CD player

Loading Discs

1. Press the OPEN and insert the disc.

2. Close the front panel. Playback begins automatically.

‘‘LOADING ’’ indicator will flash in the display window.

Note

Make sure that the front panel is closed when playback be- gins.

Playback with the front panel open causes the unit to turn off automatically in about 10 min- utes.

Labeled side up

! NEVER Insert a 3-inch CDs.

This unit is designed for playback of standard 5-inch CD’s only. Do not attempt to use 3-inch CD singles in this unit, either with or without an adaptor, as damage to the player and/or disc may occur.

Tips

•When a CD is loaded, the on the display remains lit.

•During playback of a CD, the pie-shaped signal-strength

meterspins.

ENGLISH

FRANÇAIS

PORTUGUÊS ESPAÑOL

E-7