Blaupunkt ACR4230 Traffic messages ARI, Storing stations, Recalling stored stations

Page 6

Storing stations

For each memory bank (I, II, III, T) you can store up to five stations using the button 1-5.

Select the memory bank by pressing FM•T.

Select the button 1-5to store the new station and press it.

Press to tune in the station you want to store (automatically or manual- ly).

Press the button 1-5and hold it. First the station will be muted and then be- come audible again.

The station has been stored in the memory bank.

The corresponding memory bank and the button preset will appear in the display.

Note:

If you tune into a station which has already been stored, then the corresponding button preset and the memory bank will flash in the display for approximately 5 seconds.

Storing the strongest stations automatically

(Travelstore)

In your reception area you can automatically store the five nearest FM stations, sorted according to their frequencies.

This feature is particularly useful when you are travelling.

Press FM•T for at least 2 seconds.

The radio will search for the nearest FM stations and store them in the memory bank “T” (Travelstore). When the pro- cess has been completed, the first stati- on will be set.

If you wish, you can also store stations in the Travelstore memory bank manually.

Recalling stored stations

You can recall the stored stations by pressing the corresponding buttons.

Select the memory bank.

Press FM•T until I, II, III or T appears in the display.

Select the station by pressing the but- ton 1-5, press repeatedly if necessary.

Traffic messages (ARI)

Many FM stations broadcast traffic news for their reception area at regular intervals. Sta- tions using the ARI system broadcast an “ARI signal” during their programmes, so that your car radio can recognize them. Another signal is broadcast to indicate the beginning and end of a traffic message. These traffic mes- sages are broadcast at a preset volume. If you are playing a cassette, it will be interrup- ted until the traffic message has ended and will then resume operation.

Switching the traffic messages (ARI) on and off

If you want to switch the reception of traffic messages (ARI) on or off

Press ARI.

ARI will light up in the display, when the reception is switched on.

Now the radio will only pick up those stations broadcasting the ARI signal.

Warning beep

Should you leave the reception area of the station you are tuned to, then you will hear a warning beep after approximately 30 se- conds. If you should press a button preset for a station which does not broadcast the ARI signal, then you will also hear a warning beep.

12

Image 6
Contents ACR4230 Page Table of Contents Lo m Display forStation selection Store TImportant information Radio operationStoring the strongest stations automatically Traffic messages ARIStoring stations Recalling stored stationsRemove cassette tape Cassette tape operationInsert cassette tape Fast rewindCare of your audio equipment Technical dataAppendix AmplifierBlaupunkt-WerkeGmbH