On/off

During tape or CDC operation, the set will also automatically switch to the programme offering the selected PTY within the broad- casting network.

After the PTY programme the system will remain in the radio mode.

Notice:

As earlier mentioned, these functions are currently only supported by a limited num- ber of RDS stations.

Receiving traffic programme stations with RDS-EON

The abbreviation “EON” stands for Enhan- Traffic announcement priority

	ced Other Networks, meaning the exchan-	on/off
	ge of information within a radio network.	If the priority for traffic announcement pro-
	Many FM broadcasters offer traffic messa-
		grammes is activated, “TA” will light up in
	ges for their service area at regular inter-
		the display.
	vals.
		To switch the priority on or off:
	All traffic programme stations transmit a
		• Press TIM for approximately two sec-
	special carrier signal alongside their pro-
	grammes, which is decoded by your car ra-	onds until you hear a beep.

dio. If this signal is identified, “TP” will ap- When pressing TIM while a message is

pear in the display (Traffic Programme).	being broadcast, this message will be
In addition to these, there are also stations	interrupted. The unit will then switch back
which do not actually transmit traffic pro-	to the previous condition, though the recor-
grammes themselves, but by using RDS-	ding of this message in the TIM memory will
EON they offer the possibility to receive the	remain uninterrupted.
traffic messages broadcast by another traf-	If you press the TIM button once again, “RE-
fic programme station in the same radio	CORD” will appear in the display for appro-
network.	ximately two seconds.
If you wish to have the priority for traffic an-	When interrupting an EON message, the
nouncements activated while listening to	radio will not continue to record the an-
one of these stations (e.g. NDR3), “TA” must	nouncement since it will switch back to the
appear on the display panel.	programme heard before.
If a traffic announcement is broadcast, the	The priority for other traffic messages
radio will automatically switch to the linked	remains active.
traffic programme station (in this case,	Please note that several buttons have no
NDR2) for the duration of the message and	function while a traffic announcement is
return to the original programme (NDR3)	broadcast.
afterwards.

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS