Track Scan
Press SCA to start Track Scan. Track Number blinks during scanning operation. Unit stops at each track for 10 seconds. After scanning all tracks on disc, unit advances to next disc. Unit continuously scans until user stops scan by pressing SCA, another playback control or SRC. Track Scan deactivates any
Disc Scan
Press and hold SCA for more than 2 seconds to start Disc Scan. Disc Numbers blink during scanning operation. Unit stops at first track on each disc for 10 seconds. Unit continuously scans until user stops scan by pressing SCA, another playback control or SRC. Disc Scan deactivates any
Changer Reset
In unlikely case of CD changer trouble, reset CD changer by turning unit’s power and’or ignition off, and then power on unit. (See TROUBLESHOOTING below.)
Troubleshooting Guide
The following check will assist in the correction of most problems which you may encounter with your unit. Before going through the check list below, refer back to the connection and operating procedures.
General
Trouble |
| Cause/Solution |
|
|
|
No sound. | • | Adjust the volume with the + button. |
| • | With a |
|
| position. |
|
|
|
Radio reception
Trouble | Cause/Solution* |
Preset stations are not receivable. | • The broadcast is too weak. |
Automatic tuning is not possible. | • The broadcast is too weak. |
|
|
Travel Store feature does not complete | • Not enough broadcast frequencies are receivable. |
storing of six stations. |
|
|
|
* Also make sure that antenna is connected, extended and dry inside. | |
CD Changer operation
Trouble | Cause/Solution |
|
|
CD play does not start. | • Dusty or defective disc. |
| • The ambient temperature is more than 50°C (120°F). |
|
|
The disc cannot be loaded or is | • The disc is inserted with the printed side downwards. |
automatically ejected. |
|
|
|
The sound skips due to vibration. | • The changer is installed at an angle of more than 20°. |
| • The changer is not installed on the sturdy part of a car. |
| • Dusty or defective disc. |
|
|
Error Displays
Display | Cause | Solution |
|
|
|
“CD Err” | A disc problem such as an upside | Insert the disc correctly. |
| down or dirty disc, or a | Clean the disc. |
| (computer) disc. |
|
|
|
|
“No Disc” | No magazine or disc in changer | Take out the magazine and insert the discs. |
|
|
|
If the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer or17in
the United States call