
• You can connect the 2 RCA preamp outputs to multiple external amplifiers and power multiple speakers or speaker systems through the amplifiers. (Blaupunkt amplifiers and speakers
available separately). To add front preamp output, purchase Blaupunkt part 8 634 494 218, which is included in the
• You can use a either or both of these two methods.
Connecting the Speaker Leads
To prevent short circuits or serious damage to the unit and/or speakers:
•Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle battery’s negative terminal before making connections.
•Only use speakers that have impedance ratings of 4 ohms or higher and have
•The unit’s internal amplifier is designed to handle a
•DON’T connect two speakers to a single pair of speaker leads (“in parallel”) unless both speakers each have at least 8 ohms impedance.
•DON’T connect the left and right speaker leads to each other or to the same speakers.
•DON’T connect the front and rear speaker leads to each other or to the same speakers.
•DON’T connect the negative speaker leads to each other.
•DON’T connect the positive speaker leads to each other.
•DON’T connect any active speakers (with
•Cover the ends of any unused leads with electrical tape. This will prevent them from touching the vehicle or each other and causing a
Connecting the
To prevent short circuits or serious damage to the receiver, amplifier, and/or speakers:
•Follow the amplifier’s instructions on how to connect the unit’s preamp outputs to the amplifier(s) and connect the speaker(s) directly to the amplifier.
ANTENNA MOTORSWITCH
TRIGGER SWITCH | * |
|
*
Harness has single blue lead that can be used for either antenna motor trigger or amp trigger or spliced for
use with both. (See note 3.)
*
7