DSC programming
The car radio has been equipped with DSC (Direct Software Control) to allow you to cu- stomise certain programmable, basic set- tings to suit your personal needs and prefe- rences and then store them.
The basic settings for this audio equipment were made at the factory.
In the following you can find an overview of these settings, so that you can always reset to them if desired.
If you wish to alter any of the programming,
•press “DSC”.
Use the rocker switch to select and set the functions you wish to change. The display will show you the setting you have selec- ted.
Press / to select the function.
Press << />> on the rocker switch to chan- ge or recall the values.
Note:
Whether the settings listed in the following are available or not depends on the car au- dio system model and the features with which it is equipped.
If you cannot select any of the functions li- sted here, then your car audio system is not equipped with that feature and it cannot be adjusted as a result (also see the section on “Equipment features list”).
AM ON/OFF It is possible to block out one or both of the AM wave- bands (MW/LW).
This means you will select only the wavebands you want when you press “BA/ TS”:
AM ON - all wavebands are available
MW OFF - LW, FM only
LW OFF - MW, FM only
AM OFF - FM only
AUX IN If another signal source is connected to the CD chan- ger input, you must switch AUX to ON. Press “SRC” to select the “AUX” function. “AUX” will appear in the dis- play.
BEEP Acknowledgement tone for all functions which require a button to be pressed for more than one second.
The volume can be adjusted from between 0 to 9. (0 = off)
CLOCKSET Sets the clock manually. Refer to the section on “Clock”.
CLK. MAN.
CLK. AUTO
CLK. 12/24
CD DISP.
CDC DISP
CD NAME
DISP.
Switches off hour correction function.
Read the information in the section on “Clock “.
Automatic hour correction using the RDS/CT signal. Refer to the section on “Clock”.
Switches between
To select the NAME or TIME display mode.
Refer to the section on “Sel- ecting the display mode “.
To select the NAME, TIME or CD number for the CD changer.
Appears only during CD playback.
Use this function to give your CDs individual names. Refer to the section on “CD naming”.
ON/OFF. Here you can set the clock to permanent dis- play when the audio system is switched off. The clock display will remain visible until the ignition is switched off.
DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS
55