Blaupunkt RD 104 Selecting a station, Stereo mono switch FM, Automatic seek tuning

Page 10
Storing stations

Selecting a station

This set allows you to receive FM stations between 87.5 and 108 MHz.

Automatic seek tuning /

Press / . The radio will automatically tune into the following station.

If you keep the upper or lower part of the rocker switch / depressed, seek tuning speeds up in upwards or downwards direc- tion.

up

Adjusting the seek tuning sensi-

Changing the memory bank (FM)

tivity

You can shift between the memory banks I

 

The set allows you to modify the seek tuning

and II to store and recall preset stations.

sensitivity.

The selected memory bank is indicated in the

For this:

display.

• Press lo briefly.

Press FM until the desired memory

If “lo” is indicated, the radio will only pick up

bank lights up in the display

(press repeatedly if necessary).

strong stations (low sensitivity).

 

If “lo” is not indicated, the radio will also pick

 

up less powerful stations (higher sensitivity).

The degree of sensitivity can be separately

adjusted for both levels (see chapter “DSC Using the preset buttons 1, 2, 3, 4, 5, 6 you

programming”).

can store six stations on each FM memory

bank (I, II, T).

 

DEUTSCH

ENGLISH

ITALIANO FRANÇAIS

down in short

up in short

intervals

intervals

(when AF is off)

(when AF is off)

down

Manual seek tuning << / >>

(prerequisite: AF is switched off!)

Press << or >> to change the frequency in small steps in upwards/downwards direction.

Hold down the right or left part of the rocker switch to speed up this procedure.

Stereo - mono switch (FM)

You can switch to mono when the reception quality becomes poor:

Press lo for approximately 2 seconds. During mono reception the stereo sym-

bol in the display will go out.

Each time the car radio is switched on, the radio will be automatically set to stereo reception.

It will automatically switch to mono when the reception quality becomes poor.

Select FM or TS and with FM also the desired memory bank.

Use the rocker switch to tune to a stati- on (either automatically / or ma- nually << / >> ).

Press the desired preset button and hold it down. The radio will be muted and resumes play after approximately 2 seconds. The system will also send out a beep tone.

Now the station is stored.

The activated preset button is indicated in the display.

PORTUGUES ESPAGÑOL SVENSKA NEDERLAND

23

Image 10
Contents Kiel RD 20 19 Contents Short description CD function DisplayRadio function ? / SRC Source@ 1, 2, 3, 4, 5, 6 preset buttons CD slotImportant information Traffic safetyInstallation/connection What you need to knowSwitching the code system off Switching the code system onRestart following interruption of power supply Optical indication of theft protec TionRadio operation with RDS Radio Data System AF alternative frequencyManual seek tuning Stereo mono switch FMAutomatic seek tuning Selecting a stationSampling stations briefly with Radio Scan Recalling stored stationsTo activate Scan Switching the warning beep off Automatic seek tuning startAdjusting the traffic message Priority of traffic announcementsCD operation DSC programming ScantimeAppendix Survey of DSC default settingsTechnical data AmplifierBlaupunkt-Werke GmbH