Blaupunkt RD 104 operating instructions DSC programming, Scantime

DSC programming

This car radio offers direct software control (DSC) to adapt a number of default settings to your personal needs and to store them.

In the following you will find an overview of all the default settings adjusted at the factory. To change a programmed parameter,

•press DSC.

Then use the rocker switch to select and change the functions described below. The display shows the the adjusted condi- tion.

Select function

Change-Change-

settingsetting

Select function

BEEP Achnowledgement tone for all functions where the re- spective button has to be held down for more than 2 seconds to activate the func- tion.

Adjust volume between 0 and 9 (0 = OFF).

BRIGHT The display brightness can be adjusted between 1 and

15.You may set one day and one night adjustment. Brightness of night illumina- tion:

Switch on the vehicle’s light- ing system and program the brightness value. For this, the illumination connector has to be hooked up to the electric system of the car.

COLOUR COLOUR green << >> red

CD DISP Use this function to display CD PLAY or TIME.

LED ON You can select between LED ON and LED OFF.

LOUDNESS When listening at a low level,		DEUTSCH
the loudness function will
create a more natural sound
by emphasizing the low fre-		ENGLISH
quency range.
LOUD 1	- no boost/off
LOUD 6	- strong boost

SCANTIME	the scan time (in the CD and	FRANÇAIS
	Use this function to specify
	radio mode). Choose a value
	between 5 and 30 seconds.	ITALIANO
S-DX 1	Use this function to adjust
	the seek tuning sensitivity for
	distant reception.	NEDERLAND
	DX. 1 - high sensitivity
	DX. 3 - low sensitivity
S-LO 1	Use this function to adjust
		SVENSKA
	the seek tuning sensitivity for
	local reception.
	LO. 1 - high sensitivity
	LO. 3 - low sensitivity
SPEECH		ESPAGÑOL
	Use this function for individu-
	al adjustment of the sound
	parameters, e.g. for speech	PORTUGUES
	programs.

SPEECH 0 - max. treble

SPEECH 4 - min. treble

27