Selecting a waveband
The following wavebands are available:
UKW (FM) | 87,5 | - 108 MHz, |
MW | 531 | - 1602 kHz and |
LW | 153 | - 279 kHz |
Press the “BA/TS” button to select the desi- red waveband.
Station tuning
Automatic seek tuning /
•Press /; the car radio will automati- cally search for the next station.
If you hold / pressed up or down on the rocker switch, seek tuning will speed up in the corresponding direction.
Automatic seek tuning
Up
Down
<</>> Up/down in short intervals
(on FM only if “AF” is switched off)
Manual tuning with << >>
You can also tune into a station manually. Important: AF and PTY must be switched off (i.e. the symbols do not light up in the display).
If necessary, deactivate these function by pressing “AF.TA” or “PTY”.
Manual tuning:
•Press << >>; the frequency will change in short intervals in the corresponding direction.
If you hold << >> pressed to the left or the right on the rocker switch, the frequency scan will speed up.
Scrolling through the broadcast networks (FM only)
You can use the << >> buttons to tune into stations in your reception area.
If it is possible to receive several program- mes in the same broadcast network, you can scroll through them in the forwards direc- tion by pressing >>, or backwards using the
<<button, e.g. NDR 1, 2, 3, 4,
For this to work properly you must have al- ready tuned into the stations at least once and “AF” must be active (lights up in the dis- play).
To do this, you can start the Travelstore seek operation:
•Press “BA/TS” for 2 seconds; the sy- stem will start to run through the fre- quency band.
If “AF” is not lit up,
•Press “AF.TA” until you hear a beep.
It is now possible to select stations using << >>.
Switching between the memory banks (FM)
You can switch between the memory banks I, II and T in order to store stations and re- call them later.
The currently selected memory bank will appear in the display.
•Press the “BA/TS” button as many times as necessary until the desired memory bank lights up in the display.
Storing stations
On FM, you can store six stations on the preset buttons 1 - 6 for each of the memory banks (I, II, T).
On MW/LW, you can also store six stations each.
•Select the appropriate waveband by pressing BA/TS.
42