9AUD
Use this key to activate the menu for tone control.
Treble and bass adjustment
Press “AUD” once briefly: “BASS” will appear in the display and now you ad- just this setting as desired by pressing the rocker switch to the left or the right. Use the up/down rocker switch keys to set the treble. “TREBLE” will then ap- pear in the display.
Setting the Balance (left/right) and the Fader (front/rear):
Press “AUD” twice briefly.
Now use the up/down rocker switch to adjust the volume between the front and the rear speakers. “FADER” will appear in the display.
Use the left/right rocker switch keys to adjust the volume between the left and right speakers. “BALANCE” will appear in the display.
The selected values will appear in the display. The last setting is stored auto- matically.
Switch AUD off by pressing the button again briefly.
If you do not make any adjustments to the tone within 8 seconds, the AUD mode will quit automatically.
LD - Loudness
Loudness boosts the bass frequency at low volume.
Loudness on/off: Press AUD until you hear a beep.
:DSC (Direct Software Control) Using “DSC” you can adjust pro- grammable basic settings to suit your own personal preferences.
Refer to the section on “DSC pro- gramming” for more information.
;Clock display
When the unit is switched on press “DIS” briefly and the current time will appear in the display for approximately 8 seconds.
Additional function for clock display: Press and hold “DIS” until you hear a beep to display the time permanently. If you activate another function, the time will disappear from the display for approximately 8 seconds.
<Preset buttons 1 to 6 Radio mode
You can store up to six stations in each memory bank (I, II, and “T”).
On MW and LW you can also store six stations each.
Storing stations
Tune the radio into the station you would like to store. Press the preset button on which you want to store this station (radio will switch to mute) and hold it down until the radio becomes audible again and you hear a beep.
Recalling stored stations
Select the waveband and, on FM the memory bank (“I”!, “II”, or “T”) as well. Then press the corresponding preset button
Additional function for the station preset buttons
Storing and recalling the PTY program type.
When PTY is active (“PTY” will appear in the display), then you can store and recall a program type (e.g. rock, pop, classical, news, etc.) on each for the station preset buttons for the FM wave- band.
CD mode
3/-Pause
Press the station preset button marked 3/ to interrupt CD playback. “PAU-
36