Blaupunkt RCR 27, RCR 87 Appendix, Reversing the tape autoreverse, Care notes, Specifications

Reversing the tape (autoreverse)

To change the tape direction during casset- te playback:

•Press FR and FF briefly.

At the end of a tape side the mechanism changes directions automatically to play the other side (autoreverse).

The display shows “TR 1” for track (side) 1 or “TR 2” for track 2.

Note:

If there is too much tension on the tape du- ring playback, the set may switch over by itself before having reached the end of the tape side. In this case check the condition of the cassette tape. Sometimes it helps to rewind it completely.

Care notes

To avoid possible problems, we recommend you to use C-60/C-90 type cassette tapes only. Store your tapes in a cool place away from dirt, dust and temperatures exceeding 50 °Celsius. Allow very cold tapes to warm up before playing them in order to avoid uneven tape transport. After approximately 100 hours of use, dust particles collected on the playback head or roller may lead to tape run problems and sound distortions.

Use a head cleaning tape to remove nor- mal dirt build-up. For tougher cases, use a cotton swab (Q-Tip) dipped in alcohol. Do not attempt to clean by inserting a hard ob- ject into the player!

Appendix

Specifications

Amplifier

Output power: Caracas RCR 27

2 x 5.5 W RMS power acc. to DIN 45 324 at 14.4 V

2 x 10 W max. power

	Rio RCR 87
	4 x 19 W RMS power
	acc. to DIN 45324 at
	14.4 V
	4 x 20 W max. power
Tuner
Wavebands:
FM:	87.5 - 108 MHz
MW:	531 - 1.602 kHz
LW:	153 - 279 kHz
FM sensitivity:	1.0 μV at 26 dB
	signal-to-noise ratio

FM frequency response:

35 - 15.000 Hz

Tape player

Frequency response:

35 - 15.000 Hz

Subject to modifications!

PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH

25