Blaupunkt RCR 128 Selecting a waveband, Station tuning, Switching between the memory banks FM

Page 10

Selecting a waveband

With this car radio you can select between the following wavebands:

FM 87,5 - 108 MHz

MW 531 - 1602 kHz

LW153 - 279 kHz

(Dresden RCR 128 without MW, LW).

Select the desired waveband by press- ing the BA/TS button.

Station tuning

Automatic seek tuning /

Press /; the car radio will automati- cally search for the next station.

If you hold / pressed up or down on the rocker switch, seek tuning will speed up in the upwards or downwards direction.

Automatic seek tuning

Up

Down

<</ >> Up/down in short intervals

(on FM only if “AF” is switched off)

Manual tuning with << >>

You can also tune into a station manually.

Requirement:

AF and PTY must be switched off (i.e. the symbols do not light up in the display).

If necessary, deactivate these functions:

Press AF·TA or PTY.

Manual tuning:

Press << >>; the frequency will change in short intervals in the downwards or upwards direction.

If you hold << >> pressed to the left or the right on the rocker switch, the frequency scan will speed up.

Scrolling through the broadcast- ing networks (FM only)

You can use the << >> buttons to tune into stations in your reception area.

If it is possible to receive several pro- grammes in the same broadcasting network, you can scroll through them in the forwards direction by pressing >>, or backwards using the << button, e.g. NDR 1, 2, 3, 4, N-JOY, ...

For this to work properly you must have al- ready tuned into the stations at least once and “AF” must be active (lights up in the dis- play).

To do this, you can start the Travelstore seek operation:

Press BA/TS for 2 seconds; the sys- tem will start to run through the fre- quency band.

If “AF” is not lit up,

Hold AF·TA down. A beep sounds and “AF” appears.

This fulfils the requirements for selecting stations with << >>.

Switching between the memory banks (FM)

You can switch between the memory banks 1, 2 and T in order to store stations and re- call them later.

The currently selected memory bank ap- pears in the display.

Press the BA/TS button as many times as necessary until the desired memory bank lights up in the display.

Storing stations

On FM, you can store six stations on the preset buttons 1, 2, 3, 4, 5, 6 for each of the memory banks (1, 2, T).

On MW/LW, you can also store six stations each (Dresden RCR 128 without MW, LW).

26

Image 10
Contents Dresden RCR 128 Boston RCR Page Display Display fieldContents AUD F DSC-MODE E PTY Quick referenceREL SRC/SC= BA/TS AF·TAAUD Important notes Traffic safety Installation What you need to knowClock Setting the clockTheft protection REG regional programme Radio operation with RDS Radio Data SystemFixing the release panel AF Alternative frequencySelecting a waveband Station tuningSwitching between the memory banks FM Scrolling through the broadcast- ing networks FM onlyScanning stations with Radio Scan Selecting the automatic tuning sensitivityRecalling stored stations PTY Programme TypeVaried POP Music Rock Music Classics Storing programme types Scanning stations with PTY ScanPTY priority Traffic programme station reception with RDS-EON Automatic seek tuning startSwitching the warning beep off Traffic announcement priorityCassette eject Traffic information during Cassette deck operationCassette playback Fast windingREG DSC programmingRegional function on/off Specifications Overview of the DSC factory settingsAppendix Blaupunkt-Werke GmbH