DSC programming
The car radio has been equipped with DSC (Direct Software Control) to allow you to customise certain programmable, basic set- tings to suit your personal needs and pref- erences and then store them.
The basic settings for this audio equipment were made at the factory.
In the following you can find an overview of these settings, so that you can always reset to them if desired.
If you wish to alter any of the programming,
•press DSC.
MENU 
/
will light up in the display. Use the 
/
buttons of the rocker switch to select the function you wish to change. The display will show you the setting you have selected. Press the << >> buttons of the rocker switch to change the values. Confirm the setting you have selected by pressing the DSC button.
/
Select function
<<>> Adjust/recall value
LOUDNESS Loudness boosts the bass frequencies at low volume. LOUD 1 - Low boost LOUD 6 - Max. boost
TA VOL The traffic announcement and warning beep volume can be set between 0 to 63. The message will then come through at this volume, if the standard volume is lower.
If the standard volume is set higher than the TA VOL lev- el, then the traffic report will be played at the standard volume.
REG | Regional function on/off. |
SENS DX1 To adjust the seek tuning sensitivity.
“LO” stands for local recep- tion.
“DX” stands for distant re- ception.
Select “LO 3” if you want to receive strong stations in the local area, select “DX 1” if you want to tune into weaker stations which are further away.
CLOCK 24 To switch between
CLOCKSET To set the clock manually. Press << >> to select hours/ minutes. Press 
/
to adjust the flashing value.
ON VOL To set the
MUTE To change the mute volume.
BEEP X To change the volume of the acknowledgement tone (beep) between 0 and 9.
(0 = off)
RM OFF Radio Monitor
If the Radio Monitor function is active during fast winding of the tape, the set will switch to the radio and play the station previously re- ceived.
DISPLAY ON/OFF
Display indications on or off with the car radio turned off.
32