Blaupunkt ACR 3250 Receiving traffic programme stations with RDS-EON, Recalling stored stations

Page 10

Recalling stored stations

You can recall any stored station at the touch of a button.

Select the memory bank by toggling the FM button until the desired level ap- pears in the display.

Press the corresponding preset button until the display shows the desired pre- set button.

Receiving traffic programme stations with RDS-EON

Many FM broadcasters offer traffic mess-

To switch the priority on or off:

ages for their service area at regular inter-

• Press the TA button.

vals.

When pressing TA while a message is being

All traffic programme stations transmit a spe-

broadcast, this message will be interrupted.

cial carrier signal alongside their program-

The unit will then switch back to the previous

mes, which is decoded by your car radio. If

condition. The priority for other traffic mes-

this signal is identified, “TP” will appear in the

sages remains active.

display (Traffic Programme).

 

 

In addition to these, there are also stations

Warning beep

which do not actually transmit traffic pro-

 

 

grammes themselves, but by using RDS-

If you leave the reception area of the traffic

EON they offer the possibility to receive the

programme station currently tuned into, you

traffic messages broadcast by another traffic

will hear a warning beep after approximately

programme station in the same radio net-

30 seconds.

work. If you listen to one of these stations

This alarm tone will also be released when

(e.g. NDR3), “TP” will appear in the display

pressing a preset button which has no traffic

as soon as the priority for traffic programme

programme allocated to it.

stations has been activated, i.e. “TA” must be

 

 

displayed.

Switching the warning beep off

If a traffic announcement is broadcast, the

a) Tune into another station offering traffic

radio will automatically switch to the linked

information:

traffic programme station (in this case,

Press or

NDR2) for the duration of the message and

return to the original programme (NDR3)

• press one of the preset buttons 1-6

afterwards.

 

and tune into a stored traffic pro-

 

 

gramme station.

Traffic announcement priority

Alternatively:

on/off

b) Switch off the priority for traffic an-

If the priority for traffic announcement pro-

nouncements:

Press TA.

grammes is activated, “TA” will light up in the

 

 

display.

“TA” will disappear from the display.

20

Image 10 Contents
ACR Page Table of contents Short instructions To store with Travelstore To switch between stereo and mono= Code LED Important notes Precautions Installation/ConnectionTraffic safety Entry of a wrong code number Switching on security coding Switching off security coding Re-start following an interrup- tion of the power supply REG regional programme Radio operation with RDS Radio Data SystemSelecting a station AF Alternative frequencyChanging the memory bank Selecting the seek tuning sensi- tivitySwitching from stereo to mono FM Storing stationsRecalling stored stations Switching the warning beep offReceiving traffic programme stations with RDS-EON Traffic announcement priorityMechanism/cassette tapes Automatic seek tuning start Inserting a tapeAppendix Removing a tapeFM waveband SpecificationsAmplifier Tape playerBlaupunkt-Werke GmbH
Related manuals
Manual 2 pages 45.36 Kb