JVC GET0126-001A manual Adjusting the sound, Bal, Vol

Adjusting the sound

You can adjust the sound characteristics to your preference.

1 Select the item you want to adjust.

Each time you press the button, the adjustable items change as follows:

		BAS			TRE		FAD				BAL
	(bass)				(treble)		(fader)			(balance)
			VOL			WOOFER					LOUD
	(volume)					(subwoofer)			(loudness)
Indication					To do:				Range
BAS*1				Adjust the bass.				–06 (min.)
								+06 (max.)
TRE*1				Adjust the treble.				–06 (min.)
								+06 (max.)
FAD*2				Adjust the front				R06 (Rear only)
				and rear speaker
				balance.				F06 (Front only)
BAL				Adjust the left				L06 (Left only)
				and right speaker
				balance.				R06 (Right only)
LOUD*1				Boost low and high
				frequencies to				LOUD ON
				produce a well-
				balanced sound				LOUD OFF
				at low volume level.
WOOFER				Adjust the				0 (min.)
				subwoofer output
				level.				8 (max.)
VOL*3				Adjust the volume.				00	(min.)
								50	(max.)

*1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including “USER.”

*2 If you are using a two-speaker system, set the fader level to “00.”

*3 Normally the control dial works as the volume control. So you do not have to select “VOL” to adjust the volume level.

2 Adjust the setting.

To increase the level or turn on the loudness

To decrease the level or turn off the loudness

Equalization pattern changes as you adjust the bass or treble.

Ex. 1: When you adjust “TRE” (treble)

Ex. 2: When you turn on the loudness

3 Repeat steps 1 and 2 to adjust the other items.

To reset each sound mode to the factory

settings, repeat the same procedure and

reassign the preset values listed in the table on

page 30.

ENGLISH

31