ENGLISH
Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).
1 Press SOURCE 
repeatedly to select the tuner as the source.
2If necessary, press BAND (B) repeatedly to select FM or AM. Each
time you press the button, the band changes as follows:
FM 1
FM 2
FM 3 
AM
2 Tune into a station of 88.3 MHz.
Press ¢ 
to tune into stations of higher frequencies.
Press 
to tune
into stations of lower frequencies.
Tuning into a preset station
You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on page 9.
1 Select the band (FM1 – 3, AM).
1 Press SOURCE 
repeatedly to select the tuner as the source.
2If necessary, press BAND (B) repeatedly to select FM or AM. Each time you press the button, the band changes as follows:
FM 1
FM 2
FM 3 
AM
2 Select the number (1 – 6) for the preset station you want.
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
“P1” flashes for a while.
4 Repeat the above procedure to store other stations into other preset numbers.
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example,
10during battery replacement). If this occurs, preset the stations again.
If the sound quality decreases and the stereo effect is lost while listening to an FM station
In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will be also lost.
If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity – IF FILTER” on page 20.
When using this until in an area other than North or South America:
You need to change the AM/FM channel intervals. See “To change the AM/FM channel intervals – AREA” on page 20.