JVC KD-SH55 manual Storing your own sound adjustments, To reset to the factory settings

ENGLISH

Storing your own sound adjustments

You can adjust the sound modes to your preference and store your own adjustments in memory (USER 1, USER 2 and USER 3).

•There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

4 Repeat steps 2 and 3 to adjust the other sound elements.

5 Select one of the user sound modes (USER 1, USER 2, USER 3).

1 Press EQ.

The last selected sound mode is recalled, and it is applied to the current source.

Ex.: When you have selected “POP” previously

2 Press SEL (select) to select sound elements to adjust.

Each time you press the

button, the sound elements to adjust change as follows:

LOW FREQ.* =LOW WIDTH =LOW LEVEL = MID FREQ.* =MID WIDTH =MID LEVEL = HIGH FREQ.* =HIGH LEVEL =

(back to the beginning)

FREQ. (LOW, MID, HIGH):

Select the center frequency to adjust. WIDTH (LOW, MID):

Select the band width level (Q). LEVEL (LOW, MID, HIGH):

Adjust the enhancement level.

*By pressing ¢ or 4, you can directly move as follows:

LOW FREQ. MID FREQ.

HIGH FREQ.

3 Adjust the selected sound element.

•Refer to the table below for adjusting the selected sound element.

Ex.: When you select “USER 2”

6 Press EQ to store the adjustments.

To reset to the factory settings

Repeat the same procedure and reassign the

preset values listed in the table on page 28.

Indication	Preset values
	LOW	MID		HIGH
FREQ.	50 Hz	700 Hz	8 kHz
	80 Hz	1 kHz	12 kHz
	120 Hz	2 kHz
WIDTH	1 (min.)	1 (min.)
	4 (max.)	2 (max.)
	–06 (min.)	–06 (min.)	–06 (min.)
LEVEL
	+06 (max.)	+06 (max.)	+06 (max.)

16