JVC KS-FX911, KS-FX811 manual Other convenient tape functions, Playing the current tune repeatedly

	Other convenient tape functions
ENGLISH
	Skipping the blank portions on the tape
	You can skip blank portions between the tunes
	(Blank Skip).
	When this function is on, the unit skips blank
	portions of 15 seconds or more, fast-forwards to
	the next tune, then starts playing it.
	• See also “Changing the general settings (PSM)”
		on page 16 and 17.
	1 Press and hold SEL (select) for more
		than 2 seconds so that one of the
		PSM items appears on the display.
		(PSM: see page 17.)

2 Press ¢ or 4 to select “B. SKIP (blank skip).”

3 Turn the control dial clockwise to select “ON.”

Now Blank Skip is

activated.

4 Finish the setting.

To cancel Blank Skip, repeat the same

procedure and select “OFF” in step 3 by turning the control dial counterclockwise.

Playing the current tune repeatedly

You can play the current tune repeatedly (Repeat Play).

1 Press MODE to enter the functions mode while playing a tune you want to hear over again on a cassette.

“MODE” appears on the lower part of the display, and the number buttons work as different function buttons.

2 Press RPT (repeat), while “MODE” is still on the display, so that the RPT indicator lights up on the display.

Lights up when Repeat Play is turned on.

When the tune has been played, the tape is automatically rewound to the beginning of that tune and the same tune will be played again.

To cancel Repeat Play, repeat steps 1 and 2 above again so that the RPT indicator goes off.

Note:

In the following cases, Blank Skip and Repeat Play may not operate correctly:

–Tapes with tunes having long pianissimo passages (very quiet parts) or non-recorded portions during tunes.

–Tapes with short non-recorded sections.

–Tapes with high level noise or humming between tunes.

–The Dolby NR setting does not match. For example, if Dolby B NR is on and the tape was recorded with no Dolby NR.

12