ENGLISH
Other convenient tape functions
Skipping the blank portions on the tape
You can skip blank portions between the tunes (Blank Skip).
When this function is on, the unit skips blank portions of 15 seconds or more,
•See also “Changing the general settings (PSM)” on pages 15 and 16.
1 Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display. (PSM: see page 16.)
2 Press ¢
or 4
to select “B. SKIP (blank skip).”
Playing the current tune repeatedly
You can play the current tune repeatedly (Repeat Play).
1 Press MODE to enter the functions mode while playing a tune you want to hear over again on a cassette. “MODE” flashes on the upper part of the display, and the number buttons work as different function buttons.
2 Press RPT (repeat), while “MODE” is still on the display, so that the RPT indicator lights up on the display.
Lights up when Repeat Play is turned on.
When the tune has been played, the tape is automatically rewound to the beginning of that tune and the same tune will be played again.
To cancel Repeat Play, repeat steps 1 and 2 above again so that the RPT indicator goes off.
3 Turn the control dial clockwise to select “ON.”
Now Blank Skip is activated.
4 Finish the setting.
To cancel Blank Skip, repeat the same
procedure and select “OFF” in step 3 by turning
the control dial counterclockwise.
Note:
In the following cases, Blank Skip and Repeat Play may not operate correctly:
–Tapes with tunes having long pianissimo passages (very quiet parts) or
–Tapes with short
–Tapes with high level noise or humming between tunes.
–Tapes with tunes recorded at low recording levels.
–The Dolby NR setting does not match. For example, if Dolby B NR is on and the tape was recorded with no Dolby NR.
12