Kenwood KDC-D301 instruction manual Installation Procedure Connections

Page 10

Installation Procedure

Connections

English

The O-N switch should be set according to the Centre unit in use as well as to the connected models.

When the centre unit is compatible with the "N"-operation, set the O-N switch to "N". When it is not compatible with the "N"- operation, set the O-N switch to "O" because the operation is not available. The initial setting of the switch is "N".

1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.

2.Set the O-N switch of this unit to suit the centre unit.

3.Connect the speaker input cable to the front speaker cable of the wiring hernees of the centre unit.

4.Connect the control cable to the control connector.

5.Install the unit in your car.

6.Reconnect the - battery.

7.Press the reset button on the centre unit.

2CAUTION

• Do not connect the changer control cable while the centre unit

is turned ON.

• Be sure to press the reset button after installation.

• Whether the centre unit in use is compatible with the "N"-

operation or not can be identified by referring to its instruction

manual (description of the disc control mode, etc.).

• If you use the changer switching unit, see the instruction

Centre unit

Control input

N

O

White/Black

White/Black

FRONT • L

White

Gray/Black

FRONT • R

Gray

Gray/Black

White

– +

– +

Gray

manual for the KCA-S210A included in the unit. Set the O-N

switch on the KCA-S200 to "O."

N O

• Do not let unconnected wires or terminals touch metal on the

car or anything else conducting electricity. To prevent a short

circuit, do not remove the caps on the ends of the unconnected

wires or the terminals.

• After the unit is installed, check whether the brake lamps,

blinkers, wipers, etc. on the car are working properly.

• Mount the unit so that the mounting angle is 30° or less.

R

L

2CAUTION

KDC-D301

Speaker input cable (Accessory3)

If the speaker input cable is not connected, or connected wrongly, the spectrum analyzer will not be displayed.

— 10 —

Image 10
Contents KDC-D301 Contents 2WarningTo prevent injury or fire, take the following precautions Safety precautionsDo Not Load 3-in. CDs in the CD slot Handling Compact discs Cleaning the Faceplate Terminals Cleaning the CD SlotMarking of products using lasers Except for some areas Lens FoggingStoring CDs Cleaning CDsDo Not Load CD Accessories Checking New CDs for BurrsButtons and Display OperationsPlaying CDs Switching Spectrum Analyzer Display Presetting Disc NamesEject Display Level AdjustmentTheft Deterrent Faceplate Accessories External view Number of itemsInstallation Procedure Connections Installation InstallationScrewing the Faceplate on the Unit area only Removing the hard rubber frame Removing the UnitTroubleshooting Guide Problem Possible Cause SolutionEject Specifications CD player section General