Kenwood KDC-D301 instruction manual Installation, Screwing the Faceplate on the Unit area only

Page 11

Installation

Installation

*…North & South America sales area only.

Firewall or metal support

(North & South America sales

Screwing the Faceplate on the Unit area only.)

If you want to fasten the faceplate to the main unit so that it does not fall off, insert the provided screw (ø2.6 × 12 mm) in the holes as follows.

Screw (M4X8) (commercially available)

(Accessory4)*

1

Insert one of the

HoleÁ

 

provided screws into

 

 

holeÁ so that the screw

 

 

is perpendicular to the

 

 

bottom panel of the unit.

 

2

Similarly, insert another

 

 

provided screw into

 

 

holeª.

 

Accessory8 Holeª

Bottom panel

Self-tapping

Metal mounting strap

screw

(commercially available)

(commercially

(Accessory5)*

available)

 

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

Ensure that the faceplate is fixed firmly before operating this unit.

2CAUTION

Never insert the taptite screws (ø2.6 × 12 mm) in any other screw holes than the one specified. If you insert it in another hole, it will contact and may cause damage to the mechanical parts inside the unit.

Installing in Japanese-Made Cars only.)(North & South America sales area

On cars where there is no compartment in the centre for installing a car audio unit:

Use the spacer 2 to affix the centre unit sleeve and the sleeve attached to the main unit in such a way that they are correctly aligned both depthwise and horizontally.

On cars lacking a centre

P

U

 

compartment

 

2

1

Refer to the section “Removing the hard rubber frame (P.12)”

 

and then remove the hard rubber frame.

2

Align the holes in the unit (two locations on each side) with the

 

vehicle mounting blacket and secure the unit with the accessory

 

screws.

T

N

 

 

 

 

 

 

 

 

 

8 mm

8 mm

 

 

 

 

 

 

 

 

 

 

MAX.

 

 

 

 

 

MAX.

 

 

 

 

 

 

N

T

T/N

5mm

6

5mm

7

T: Toyota cars

Accessory6...for Nissan car

N: Nissan cars

Accessory7

...for Toyota car

 

2CAUTION

During installation, do not use any screws except for those provided. The use of different screws might result in damage to the main unit.

Damage may occur if a screwdriver or similar tool is used with excessive force during the installations.

— 11 —

Image 11
Contents KDC-D301 2Warning ContentsDo Not Load 3-in. CDs in the CD slot Safety precautionsTo prevent injury or fire, take the following precautions Lens Fogging Cleaning the Faceplate Terminals Cleaning the CD SlotMarking of products using lasers Except for some areas Handling Compact discsChecking New CDs for Burrs Cleaning CDsDo Not Load CD Accessories Storing CDsPlaying CDs OperationsButtons and Display Presetting Disc Names Switching Spectrum Analyzer DisplayTheft Deterrent Faceplate Display Level AdjustmentEject External view Number of items AccessoriesInstallation Procedure Connections Screwing the Faceplate on the Unit area only InstallationInstallation Removing the Unit Removing the hard rubber frameProblem Possible Cause Solution Troubleshooting GuideEject CD player section General Specifications