Accessories
External view | Number of items |
Installation Procedure
1. To prevent a short circuit, remove the key from the ignition and |
disconnect the - battery. |
English
1
2
3
4
5
6
2CAUTION
..........................................1
..........................................1
..........................................2
..........................................1
..........................................4
..........................................4
2. | Make the proper input and output wire connections for each unit. |
3. | Connect the speaker wires of the wiring harness. |
4. | Connect the wiring harness wires in the following order: ground, |
| battery, ignition. |
5. | Connect the wiring harness connector to the unit. |
6. | Install the unit in your car. |
7. | Reconnect the - battery. |
8. | Press the reset button. |
2CAUTION
• If your car's ignition does not have an ACC position, connect |
the ignition wires to a power source that can be turned on and |
off with the ignition key. If you connect the ignition wire to a |
power source with a constant voltage supply, as with battery |
wires, the battery may die. |
• If the console has a lid, make sure to install the unit so that the |
faceplate will not hit the lid when closing and opening. |
• If the fuse blows, first make sure the wires aren’t touching to |
cause a short circuit, then replace the old fuse with one with |
the same rating. |
• Do not let unconnected wires or terminals touch metal on the |
car or anything else conducting electricity. To prevent a short |
circuit, do not remove the caps on the ends of the unconnected |
wires or the terminals. |
• Connect the speaker wires correctly to the terminals to which |
they correspond. The unit may be damaged or fail to work if you |
share the - wires or ground them to any metal part in the car. |
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above.
• After the unit is installed, check whether the brake lamps, |
blinkers, wipers, etc. on the car are working properly. |
• Insulate unconnected wires with vinyl tape or other similar |
material. |
— 12 —