Kenwood KRC-108S instruction manual Removing the hard rubber frame, Removing the Unit

Page 15

■Removing the hard rubber frame

1Engage the catch pins on the removal tool and remove the two locks on the lower level.

Lower the frame and pull it forward as shown in the figure.

Catch

Lock

■Removing the Unit

1Refer to the section “Removing the hard rubber frame” and then remove the hard rubber frame.

2Remove the Hex-head screw with integral washer (M4⋅8) on the back panel.

3Insert the two removal tools deeply into the slots on each side, as shown.

Accessory3

Removal tool

2When the lower level is removed, remove the upper two locations.

Accessory4

4Lower the removal tool toward the bottom, and pull out the unit halfway whilst pressing towards the inside.

Catch facing up

Accessory3 Removal tool

NOTE

The frame can be removed from the top side in the same manner.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.

5Pull the unit all the way out with your hands, being careful not to drop it.

— 15 —

Page 14 Page 16
Image 15
Page 14 Page 16
Contents KRC-108S Contents To prevent injury or fire, take the following precautions Safety precautionsCleaning the Unit Cleaning the Tape HeadHandling Cassette Tapes General features PowerSwitching Modes Loudness VolumeAudio Control Setting AttenuatorClock display Adjusting TimeFD Adjust the fader level Ec4/dB Sound CoordinateRecalling a Preset Station Tuner featuresTuning Station Preset MemoryClean Reception System Circuit Crsc Auto Memory EntryTurning Crsc On/Off Cassette player features Playing Cassette TapesFast Forwarding and Rewinding Cassette Tapes Turning Tuner Call On/Off Tuner CallInstallation Procedure AccessoriesACC Connecting Wires to TerminalsInstalling in Japanese-Made Cars InstallationRemoving the Unit Removing the hard rubber frameProblem Possible Cause Solution Troubleshooting GuideAudio section SpecificationsAM tuner section Cassette player sectionPage
Top Page Image Contents