Aiwa CT-Z110 operating instructions To preset stations manually, To tune in a preset station

To preset stations manually

You can manually preset stations that have not been selected by an auto memory operation.

1 Press PWR to turn the unit on.

2 Press FUNC repeatedly to select the band from among FM1, FM2, FM3, AM1, and AM2.

3 Tune in the station that you wish to preset with TUNE i or TUNE k.

4 Press and hold one of the preset station buttons 1 to 6 for approximately 2 seconds.

While the station you are presetting is being registered in memory, the unit beeps.

The preset station number appears to the right of the frequency indication.

Frequency	Preset station
indication	number

Repeat these procedures to preset up to 6 stations each for FM1, FM2, FM3, AM1, and AM2.

•If you preset a station on a preset station button on which another station of the same band has already been preset, the previously preset station will be erased.

To tune in a preset station

1 Press PWR to turn the unit on.

2 Press FUNC repeatedly to select a desired band from among FM1, FM2, FM3, AM1, and AM2.

3 Press the desired preset station button.

The preset station number appears to the right of the frequency indication.

Active tuning reception control (ATRC)

This unit automatically suppresses FM noise caused by varying signal strength resulting from movement of the car.

•The built-in automatic blending circuit mixes the left and right channel signals according to the strength of the reception. At the same time, the high-cut circuit activates to maintain sound quality.

•If the reception becomes even weaker, the unit automatically switches to Monaural mode to reduce noise.

ENGLISH 6

CTZ110(YU)-total-En-7